Jump to content
SAU Community

Recommended Posts

Lumpy start and having to hit the throttle a little on Cold Start seems to be quite common.

Mine does it sometimes but I still haven't found a fix for it. (I have searched a plenty).

If this is all it is, don't worry about it.

Buy it.

Love it.

Lumpy start and having to hit the throttle a little on Cold Start seems to be quite common.

Mine does it sometimes but I still haven't found a fix for it. (I have searched a plenty).

If this is all it is, don't worry about it.

Buy it.

Love it.

i sorted mine originally by playing with the tps voltage....lasted 5 months and gone lumpy on cold again...

haha yea and its cheap and clean as hell! stock but 80kms that sound genuine!

wont be gen. never is. EVER.

its not the lumpy start tho, its more of it jsut trying to turn over, takes a few goes to actually turn over then once it turns over its lumpy for about 5 seconds

turn ignition on for a few seconds with out starting it. turn key give some revs. until it grabs idle at 1100rpm. should then be sweet.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I checked spark on all cylinders and they all visually have spark with the plug pulled and grounded, but plug 1 is the only one that fouled. This was a running swap that blew up and was rebuilt by a machine shop, put a new wiring specialties harness and did all gaskets, studs, and bolts while it was out.  compression is 135-150 across all cylinders. Aside from that from my understanding with the z32 ecu and maf the car should start regardless. The wiring for TPS and the dual 02 sensor/ dual knock sensor stuff shouldn’t actually stop the car from starting or even running well, (just slightly rich)  they just give fault codes. Car supposedly is supposed to start as long as you have z32 afm and ecu with the nistune base map and that’s info coming from a well known and trusted tuner who does a lot with SR/RB (Rsenthalpy). After more trouble shooting today where I’m at right now is that the cas is sending signal to the injectors they click while spinning the rotor, Fuel pressure is now set at 43psi, all cylinders have good compression and all of the plugs looked great (just wet with fuel) except for cylinder 1 which was very black (cylinder 1 has 150psi compression). all of the coils generate spark if pulled out and grounded out on the head. On the fuel pump car just pops into the exhaust. On starting fluid car will fire off. Hard to tell if all cylinders are firing off but definitley a couple. sounds like all of them but it’s only for 3-5 seconds hard to tell. 
    • Final update!!! Got the front bar fitted and sprayed and all sorted now. My cutouts worked great and the indicators aren’t just falling off. 😂  
    • Is this a brand new LSD? if so, have you followed any break/bed in procedure for it? Usually involves heaps of figure 8 patterns, a fluid flush.
    • It's TWO steering wheels actually. 😛 one for each hand They are wheels, and they steer!
    • Did you even watch the video? Its not a steering wheel. 
×
×
  • Create New...