Jump to content
SAU Community

Recommended Posts

Hey everyone i have a complete 5speed manual conversion for a ca18det engine to suit a s13 or 180sx


Gearbox with shifter


clutch master and slave cylinder with lines


sandwich plate


all brackets and mounts


flywheel just been machined


new oem clutch only used for 5000ks


Brake and clutch pedal


tail shaft


gearbox mount


everything you need to convert your auto to a manual shifts smoothly in every gear no crunches in awesome condition clucth like new

call or text me on 0432-062-780 located in melbourne

post-62515-0-82032000-1367245467_thumb.jpg

post-62515-0-32004600-1367245812_thumb.jpg

post-62515-0-80432900-1367245848_thumb.jpg

post-62515-0-83276500-1367245916_thumb.jpg

  • 3 years later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Have you flushed the initial fluid yet? It should look like a rainbow unicorn shat glitter into it. 2nd or 3rd fluid change is when you party.
    • all brand new unit from Tomei, fluid, bearings, etc. Tomei said they call it a 1.5 lsd because its 100 percent lock up under acceleration and 50 percent under deacceleration.  as I mentioned I used their fluid, install and their break-in procedure, (alot of figure 8's) but even when driving straight, or even slowly backing out of garage for first time, (at 2 mph) then driving to and from figure 8 parking lot, each tire in the rear would sporadically grab, skip, bounce, shutter and skip, shutter back a force I could feel causing clutch to slip then grab, at any speed. shaking entire car. I removed unit, since I put stock back in and all is fine, via process of elimination, its something with the lsd unit itself. I wasn't going to beat up the entire car more or change anything else for no reason as I had a feeling something in the lsd itself was wrong as everything was fine before this alone was installed and I rechecked over everything else after first time backing out I suspected an issue. I'll probably sadly already need new tires now just from trying to drive it 5 miles and performing the figure 8 break in. but if someone has any ideas I'm all ears 
    • Ok thanks..that was my second question if i can somehow bypass this even with Nistune(that is all i have right now...aparat from stock ECU. So with some aftemarket it can by "bypassed" or make it work?  I know there is Link or Haltech (mainly used). We have ECUmaster here so i will gather some info about it.
×
×
  • Create New...