Jump to content
SAU Community

Recommended Posts

hey guys I have some stuff left over from the silver r33 coupe I recently parted out, parts left include:

not much left now only have:

stock air box - $180

boot interior - $70

clutch pedal/master/lines/slave - $150

abs bmc - $50

booster $50

rear seats - $20

front and rear door cards - $100

f & r pillar trims - $20 each

dash - $50

glovebox - $30

s1 centre console - $30

bonnet - $100

boot lid with wing - $100

front bar (m spec s1) - $100

rear reo bar - $50

bonnet latch and stand - $50

washer bottle - $20

coolant bottle -$20

pass window switch - $30

engine crossmember -$50

hicas steering rack - pending payment

rear suspension arms - from $20

mirrors - $60

good flywheel - $100

fuel filler flap - $25

fuel pump and cradle - $50

probably more little bits around but thats most of what I have left...

located in springwood 4127

please contact me on 0420 767 957

Cheers

  • 2 weeks later...

also got a series 1 shell here now to part out (complete coupe shell)

still got heaps of s2 parts as well and lots of r32 stuff

rb25det block complete unknown condition bores look very good - $100

  • 2 weeks later...
Guest
This topic is now closed to further replies.


  • Similar Content

  • Latest Posts

    • Is it alright to top up with just another green coolant?
    • thanks GTSboy. My confusion at the moment is i am trying to locate the ignition, ECU battery power and the ECU negative The closest thing i can find is the for the S15 on Page 8 of the Wiring Specialties web page https://drive.google.com/file/d/0B9F33_M_GgENQnZ6STMxVmVNd1E/view?resourcekey=0-eZ4nNRwRoqa1qvKlWWHm8A I cannot find the same diagram for the R33 RB25DET Series 2 dash plug pin out.... Do you know what the Pins? or know where i can find the same pinout diagram for the RB dash plug? Thanks for the advice on the box... i like a 6 speed so might be on the lookout or the box now.. a topic of discussion for another post...
    • Will have a look at that. I cant see any leaks 
    • Put another overflow bottle (ie, a 1.25 coke bottle or similar) under the overflow hose and see if it is being pushed out there or if it is disappearing into the engine.
    • Staring on a stand is no issue. You just have to wire everything up, give it fuel and cross your fingers that the stand is robust enough. Arranging the inlet plumbing is often the hardest part, without any surrounding structure to hand some of it from. No need for coolant if you only want to run it for <1 minute. As to the gearbox - I think the little Aisin box is a bit stronger than the other small Nissan boxes that went behind SRs, but I wouldn't be too keen to test its limits with the torque of a boosted 25. I don't know if you can retain the box and the tailshaft. The box won't connect to the RB without an adapter of some sort, which is either a plate that will push the engine forward (which is not good for fitting it into the bay's available space) or push the box back, which messes with the box position and tailshaft length - OR - cut and shut work on the bellhousing, which is a long way from "least modification". I'd be buying a new 370Z 6 speed or similar, doing what has to be done to that to make it fit RB (ie, cut and shut bellhousing) and the requisite tailshaft custom/mods.
×
×
  • Create New...