Jump to content
SAU Community

Recommended Posts

HKS Superdragger SR JASMA

3" Inlet, 6.5" Muffler, 4.5" Tip.

Includes Tip, Muffler, back to Mandrel Bend, Flange plate. Great for top end power.

Good condition, recently polished and coated.

$220 Neg.

Contact James at [email protected] or 0401 348 776

Image(02).jpg

Image(04).jpg

Owww ok, its just that i took it to Powerplay Imports and they rekoned it was a Superdragger. Afterlooking at the HKS web site, it looks like a Superdragger II to me, Yes, its def not the original model, but looks like the II model. I've never seen the Hyper model on their web site, but yes, it does look like it.

is not a super dragger 2 either cause the muffler is rounded like the original.

this is clearly the hyper muffler.

anyway is not suitable for nissans cause the piping bends the wrong way. suitable for cars with mufflers on the right side of the car.

out

This was taken straight off my r33 gtst. so yeh, fits skylines no probs... Minimal bends for maximum flow. You can make it fit whateva you want it to fit, you would cut off the current pipe and weld the muffler to what you already have.

I use a twin tip now, thats why im selling.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I don't care for these at all, but at least the underside looks straight and not rusty. A good basis for a long life. Many cars from Japan have been lifted with forklifts and f**ked almost irrepairably.
    • Yes, but it's not dumb or dodgy. You can build a perfectly good boost controller from a pressure reg, a relief valve (looks same same as a reg if all from Norgren or SMC, for example) and a check valve. I ran one for years. Only superceded with  EBC because I could get one for cheaps and wanted finer control.   THis mod is certainly not a sketchy boost mod, provided the boost is kept below the "spin to death" threshold of the turbos.
    • With ordering the belt, you're doing water pump and the idler and tensioner at the same time too yes?
    • This is just a dumb way of keeping the wastegate closed to make more boost. Undo it and either follow the factory setup or redo it properly. Manual boost controllers just use a spring preload to determine when to close in response to boost pressure so it no longer vents to atmosphere.
    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
×
×
  • Create New...