Jump to content
SAU Community

Recommended Posts

4 cars at our home > one car has a python sytem - another has a viper system.

When the viper goes out, the python is happy > sleeps.

When the viper comes in, the python gets excited > goes off.

When the python is activated or deactivated, the viper sleeps.

When the viper is activated or deactivated, the python sleeps.

Anti-Troll says, there is no cobra involved. :P

Link to comment
https://www.sau.com.au/forums/topic/428930-snakes-alive/
Share on other sites

Proof!

SAU had a cruise yesterday...

At the truck stop along Putty Rd....

* Bikes did not set it off

* Even Harleys did not set it off

* EVOs did not set it off

* R33 GT-Rs did not set it off

* R34 GT-Ts did not set it off

* Nor did VW Golf TDi, Sylvias, GTsTs

* Not even a R34 GT-R V-Spec

*** A R34 GT-R V-Spec II Nur SET IT OFF-F-F-F!!! It also has an N1 engine > so is it a particular frequency?

lol

Link to comment
https://www.sau.com.au/forums/topic/428930-snakes-alive/#findComment-6938597
Share on other sites

  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • I don't care for these at all, but at least the underside looks straight and not rusty. A good basis for a long life. Many cars from Japan have been lifted with forklifts and f**ked almost irrepairably.
    • Yes, but it's not dumb or dodgy. You can build a perfectly good boost controller from a pressure reg, a relief valve (looks same same as a reg if all from Norgren or SMC, for example) and a check valve. I ran one for years. Only superceded with  EBC because I could get one for cheaps and wanted finer control.   THis mod is certainly not a sketchy boost mod, provided the boost is kept below the "spin to death" threshold of the turbos.
    • With ordering the belt, you're doing water pump and the idler and tensioner at the same time too yes?
    • This is just a dumb way of keeping the wastegate closed to make more boost. Undo it and either follow the factory setup or redo it properly. Manual boost controllers just use a spring preload to determine when to close in response to boost pressure so it no longer vents to atmosphere.
    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
×
×
  • Create New...