Driveshaft Centre Bearing - R33

[simpletool]

Anybody know the CORRECT part for an R33 GTST centre bearing?

I've got my old bearing off and realised the R32 bearing will not fit. The ID/OD of the mating shrouds are incorrect - at both end. So it both won't go onto the drive shaft and the end won't be able to go on after the bearing.

Used part NP-30-6250 from Hardy Spicer. Bought from Just Jap. A few sites list these as compatible for R32 and R33. I can't see how.

These flanges look different to the factory item also. There is a double flange on one side that is NOT on the factory item which means it won't fit. Also the driveshaft end has a thick flange where the ID is smaller than the driveshaft at that point by 2 mm.

Edited July 27, 2013 by simpletool

[simpletool]

Also this is a series 2 R33. So maybe they swapped the bearing type?

OK, a bit more google searching and it's the same as S14, S15, R34. I'll get it from Nissan.

Edited July 27, 2013 by simpletool