Jump to content
SAU Community

Recommended Posts

Pretty sure iv seen this in Kent street Hamilton area

Yeah I visit that area sometimes so id say it was me,

Did you have to take the inner guard lining out to fit your grids btw or roll the guards?

I had the guards rolled when they were fitted and the guy zip tied the lining to the guards, bit fiddley but can be done.

are they direct plug in to loom or do u have to get the plug for the injectors and is there any chance of some better pic of it all and is the fuel reg still attach to fuel rail. i keen on it all just what more info

are they direct plug in to loom or do u have to get the plug for the injectors and is there any chance of some better pic of it all and is the fuel reg still attach to fuel rail. i keen on it all just what more info

I will Remove the parts tomorrow and give you a photo of the exact setup and parts, The plugs are part of the sale as I am looking for the stock rail etc off whoever buys this...

cant believe this hasn't been bought yet... the injectors alone are worth $600 and about the best injector on the market.. :/

Edited by AngryRB

PRICE REDUCTION

Fuel setup $650 or $600 +exchange for a stock rail+injectors

post-70965-0-56838000-1378645567_thumb.jpgpost-70965-0-81001700-1378645589_thumb.jpg

Rear Bumper $100

Tein coilovers HA $600 or $500 + exchange for stock suspension

Rota Grids - $700

2 GTR BOV's $70

GTR Cluster $350 or $300 + a stock cluster

Tomei Poncams- $500 + stock cams

P.S- DO NOT ask me to bring the parts to you, do I look like a courier service?? giving me the shits..

Edited by AngryRB

Can I get more pics of coilovers?

There still on car, they are all green like the last pic, will post more pics soon, all in Perfect working condition

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Probably speedometer itself if the odometer is ticking. If the needle is stuck from a bit of grease or something that can cause it to stay at 0. Or a cracked solder joint in the speedometer can do it too.
    • Thanks Fella’s   to take this off topic and to elaborate a bit more. I have an rb25/30 going into a r32 GTST.. expected to make around 600-700hp. Would you?   A) R34 GTT box   B) CD00#?  I’ve seen a few posts about the CD swap and sounds fairly involved with making it fit etc but if it’s worth the work then I’ll go that way
    • Lower at the hubs. Funny I forgot to mention that part. Do this pull here I turned the camera off too soon but the graph shows a drop at the top and that was because the pipe from the turbo blew off. The tuner said we could’ve made possibly another 15 whp. He also added if I switched to ethanol we could up the boost some more as well. I was comfortable capping it at the most of 20 pounds. Turns out the turbo pipe just needed a new worm clamp. Got home replaced that then did a third gear pull from 3k to 7200 rpm and the power was great to the top. I just got an ecu mounting bracket from IEE that I need to try and get everything to fit well. It’s a PITA to get the harness and ecu fit properly behind that kick plate 
    • He means "as opposed to mechanical cable drive". Older cars (R32 for ex.) had cable drive. Later cars with essentially the same gearbox, ie R34 GT (NA RB25) used essentially the same box as the R32 GTSt, but instead of a cable drive, had an electronic speed sender plugged into the same hole in the box, running from the same little gear that would have run the cable. Some of the shittier later cars use a speed sender on the nose of the diff, or the ABS sensors.
    • Lower than engine, or lower than it should at the hubs? Either way, that is a nice power figure and I'm not surprised you say it rips now. What stopped you from turning it up any more? Injectors? Or did it just stop responding to boost?
×
×
  • Create New...