Jump to content
SAU Community

Mugabetown - Whoretownin' At It's Worst.


Recommended Posts

I've been forever pondering lately what gets prioritised through workshops / tuners

seems like FIFO is not something you can rely on as turnaround indicator

I think FIFO is the goal, but in your instance it was something that required extra work they didn't account for so inorder to get more cars out faster yours sadly went on the back burner :(

Whatever order makes them the most money the fastest?

here are my thoughts

regular service work = consistent cash flow = priority no.1

sponsoring work = zero immediate cash flow but free advertising = potential future cash-flow = priority no.2 (my mind is still debating this)

project work = infrequent cash flow = priority low

all the above depends on size and demographics i.e. manpower of the workshop(s) but as a general rule of thumb I don't think I'm too far off the mark.

Also for non service work i.e. large repair jobs or builds - if a workshop tells you it will cost you this much $xxx - budget for $xxx * 2 as there will always be additional costs they fail to mention (unless you know someone who will do it at a discount or lower chargeable rate)

Or get Dan to build your engine...

I'd say sponsored work goes to the back unless it will have immediate impact on future business, e.g. a sponsored car shits a bearing right before major event. This is bad as visibility is important so it'd go up the queue, otherwise it'd be dead last IMO

Or get Dan to build your engine...

I'd say sponsored work goes to the back unless it will have immediate impact on future business, e.g. a sponsored car shits a bearing right before major event. This is bad as visibility is important so it'd go up the queue, otherwise it'd be dead last IMO

would really depend on the type of sponsor being provided to really answer that question

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • How many of you guys run the synchro os giken set and at what power? Do you then also use the billet plate?  How is it launching with it, any dragy times from 0-60? 60ft?
    • Oh, also, forgot to add these photos I believe.
    • Thought i'd update on this. I was able to get in contact with Craig Lieberman and later on Darryl Alison (owner of Kaizo Industries). Darryl was able to help me verify that my car was in fact one of theirs and is helping me find more info on mine !
    • There's restrictor pills in the stock boost control hoses. That's how they set the amount that was bled off and hence the "high" boost setting. The usual mod in the day was to remove it and send the "high" boost setting up to about 14 psi.
    • Thanks Duncan, that's the best info I've read. Furthermore after learning about the PCM programming side controlling the factory boost solenoid, the purpose of the solenoid is to "bleed" boost when pin 25 is earthed, thus allowing spring pressure in the wastegate actuator to overcome diaphragm boost pressure, thus closing or reducing the position of the wastegate flap creating more boost as the turbo is able to spin faster. It's pretty cool to see a designated Pill to do exactly this, would have liked to have seen it with a tiny filter over the end for those moments in vacuum.  The constant bleed pill has now been removed completely from the system and solenoid boost control has been restored once again.   Case closed 😂
×
×
  • Create New...