Jump to content
SAU Community

Mugabetown - Whoretownin' At It's Worst.


Recommended Posts

I just want some cheap 4/5 stud wheels to throw some track tires on, so that I can run them on either car

Now, probably wasting my time, but I have these lying around (tyres not included, unless you want to pay a lot extra)

Do you like roller blades? (narrow is good for skidz..., ask anyone who spent too much on an underpowered 86) :D

Have some 17x7" 45mm offset wheels with 4/5 stud pattern

Enkei 'Orsh Varents'

post-78416-0-66140700-1401792128_thumb.jpg

post-78416-0-17934800-1401792170_thumb.jpg

(the worst one, some nicks on the others though)

post-78416-0-10006300-1401792193_thumb.jpg

Recently repaired and refurbished by Depulu Wheels (courtesy of a suspension shop who doesn't know how to put wheel nuts on the right way around),

Then re-rashed by a clumsy Legnum driver (who never once rashed them himself until after they were refurbed :'( )

And incase you think they are just for 'fagnums', here is one of the only pics of the same wheels on the internet

post-78416-0-76477300-1401792726_thumb.jpg

(no idea if offset is the same though)

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • Possibly avoid using a Cometic one unless the deck/head surface are perfectly flat. I did have a look just then and forgiving gaskets such as Tomei or Nitto don't exist for the FJ20, however the Bar-Tek or Kameari ones look good and might do the trick.
    • Because pipe threads for pipe things. M threads for bolt things. Throw some teflon sealant onto it and dust your hands off knowing you did the right thing, instead of going twice around the block to achieve a result using the wrong things. Of course, all of these solutions are ignoring the fact that the minimum thread pitch we're talking about here is 1.25mm, with the 1/4" in NPT or BPS being out around 1.4mm. You will need to know that the boss you're tapping has enough thickness for at least a few threads. That's one of the reasons that 1/8" is commonly used - because the pitch is <1mm. And why would you look to use 1/4" NPT in a BSP country anyway? Ugh.
    • Just throwing around ideas, does it need to be in the compressor cover? Why not the hot side piping?
    • 1/8NPT drill size = 8.7mm. Since the hole got messed up by me, it’s probably around 9mm.    So 1/4” NPT would be next step. A drill size of around 11mm would be preferred there which is not way of my M12 (drill 10.5mm and tap M12 threads) 
    • 3 Kids are starting to hit that ages. I wanted to get them something special to learn on, put down the screens and have some fun. 4Door 2001 R34DE Black Pearl GV1 Jap Import, AU 2nd owner. Pre Work done. Suspension - Wheels Pedders SportsRyder Coilovers   Wheels TSG Spokey Boi 18'x9.5"+15 Body JASI Aero 4 door Type R Full Kit LED Conversion - Parker, Blinkers, & Reverse Exhaust Hurricane Headers 100 CPI high flow cat 2.5" Piping Cannon muffler Internal Bride low max stradia ii - front seats  Bride RO seat base and Rails (R/H) Cube short shifter LED Conversion - Interior   
×
×
  • Create New...