Jump to content
SAU Community

400Hp+ Package

116.hks

By 116.hks,
in Classifieds

 Share

Recommended Posts

116.hks Community Regular

116.hks

Posted
Posted

Hey guys. Up for grabs is a complete 400+hp package. This setup has produced a comfortable and reliable 424rwhp at 20psi on my RB25 for the last few years. The package includes a genuine Garrett GT3582r ( Polished front cover and .82 rear housing ), black HPC coated stainless high mount manifold, 3.5inch dump pipe which is heat wrapped, external gate with screamer pipe, BMI billet fuel rail with 620cc top fed injectors with -6 fittings and custom LS1 coil conversion. The turbo has done roughly 5-10,000k's in the last 6yrs, as it doesn't get driven much anymore and no shaft play. The turbo is still fitted to the car and can be heard running but unable to be driven due to no rego. Water lines will be included as well.

Asking $2000 for the lot as a complete package. Not interested in separating as this point. Contact Brad 0407 166 639.

post-53870-0-75898600-1379933599_thumb.jpg

post-53870-0-18574400-1379933700_thumb.jpg

Link to comment
https://www.sau.com.au/forums/topic/432237-400hp-package/
Share on other sites
  • 3 weeks later...
116.hks Community Regular

116.hks

Posted
  • Author
Posted

Willing to separate or still sell as a complete package for $2000.00.

GT3582r and Dump Pipe $1000.00

Manifold and External Gate $450.00

Fuel Rail, Injectors, -6 Braided Lines, Billet Fuel Filter and Turbosmart FPR800 $300.00

Custom LS1 Coils and Leads $400.00

Link to comment
https://www.sau.com.au/forums/topic/432237-400hp-package/#findComment-7059335
Share on other sites
 Share
Go to topic listing


  • Latest Posts

    • Dose Pipe Sutututu
      What brakes on R34 GTT(Europe)

      By Dose Pipe Sutututu · Posted

      Pads for R32 GTS-t, R32 GT-R non V-Spec (Sumitomo), R33 GTS-t and R34 GT-t are all interchangeable. R34 GT uses a 2x piston caliper, hence it didn't fit.
    • soviet_merlin
      WGNC34 - floor mats

      By soviet_merlin · Posted

      Checked with amayama and nope, the full S2 manual set is not available anymore. Unsurprising, but still disappointing as the ? on availability gave a glimmer of hope.
    • joshuaho96
      Tomei gasket

      By joshuaho96 · Posted

      I've heard the Tomei USA head gaskets are decent if you want to o-ring the heads but otherwise not recommended.
    • GTSBoy
      What brakes on R34 GTT(Europe)

      By GTSBoy · Posted

      The 296mm rotors are the R33 turbo brakes. The 310mm rotors are the R34 turbo brakes. The calipers are nearly the same, but not. They're the same caliper but the R34 caliper has longer legs so that it sits out far enough to go over the rotor. The pads are the same for both. When you say, "I bough tsome EBC"....did you just mean pads? Or rotors? 310mm rotors fit under 17" wheels. There may be some wheels without enough clearance though. I can't fit my fingers between the barrel of my wheel and the "corners" of my R34 calipers, but there is plenty of room behind the spokes. This is on Enkei RPF1. You can fit 324mm rotors inside a 17" wheel, but I'd be willing to bet that it would be close to impossible with the Nissan/Sumitomo caliper (using an adapter, of course), because the Sumitomo caliper is fatter than the Brembo caliper that is supposed to go on the 324mm rotors.
    • Kapr
      What brakes on R34 GTT(Europe)

      By Kapr · Posted

      Hi. Can someone tell me what brakes(and mainly WHERE) can i buy brakes on R34 GTT? I bought some EBC which SHOULD go on my car(i have GT but it has GTT brakes) but it does not fit, Brakes are "too" small(296mm) Are 310mm be good or? I have 17 inch wheel so no "big boys" but for me driving i just need one that fits and i can get here in EU/Czech.
×
×
  • Create New...