Jump to content
SAU Community

Recommended Posts

Hi all,

I am after information on 1990 r32 nismo's.

I realise that there were 560 of them made, 60 of which were kept by nissan for racing. But other that that I have found no accurate information on them. This is mainly because the nismo's seem to be able to be optioned with anything the buyer wanted.

Any info or help would be greatly appreciated.

Link to comment
https://www.sau.com.au/forums/topic/438207-r32-nismo-info/
Share on other sites

Nismo.jpg

Nismo_1.jpg

A Genuine R32 GTR Nismo Edition would have to be determined by the VIN Number.

But Cosmetic / Body wise, it has the Nismo sticker on the boot lid (Pic Above).

The bonnet has a lip spoiler attached to it as it would help feed air to the grill to improve flow to the radiator.

The front bar has two vents added on to allow more air flow to the intercooler.

A 3 piece side skirt was added.

A boot lid spoiler was attached under the factory spoiler to improve rear down force.

An upgrade of Nismo Twin Turbos bolted on from factory, capable of 600 PS.

  • Like 1
Link to comment
https://www.sau.com.au/forums/topic/438207-r32-nismo-info/#findComment-7182211
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Well the install is officially done. Filled with fluid and bled it today, but didn't get a chance to take it on a test drive. I'll throw some final pics of the lines and whatnot but you can definitely install a DMAX rack in an R33 with pretty minor mods. I think the only other thing I had to do that isn't documented here is grind a bit of the larger banjo fitting to get it to clear since the banjos are grouped much tighter on the DMAX rack. Also the dust boots from a R33 do not fit either fyi, so if you end up doing this install for whatever reason you'll need to grab those too. One caveat with buying the S15 dust boots however is that the clamps are too small to fit on the R33 inner tie rod since they're much thicker so keep the old clamps around. The boots also twist a bit when adjusting toe but it's not a big deal. No issues or leaks so far, steering feels good and it looks like there's a bit more lock now than I had before. Getting an alignment on Saturday so I'll see how it feels then but seems like it'll be good to go       
    • I don't get in here much anymore but I can help you with this.   The hole is a vent (air relief) for the brake proportioning valve, which is built into the master cylinder.    The bad news is that if brake fluid is leaking from that hole then it's getting past the proportioning valve seals.   The really bad news is that no spare parts are available for the proportioning valve either from Nissan or after market.     It's a bit of a PITA getting the proportioning valve out of the master cylinder body anyway but, fortunately, leaks from that area are rare in my experience. BTW, if those are copper (as such) brake lines you should get rid of them.    Bundy (steel) tube is a far better choice (and legal  in Australia - if that's where you are).
    • EMU Classic. For what I need it to do I see no reason to upgrade. Link and Haltech would both cost an extra chunk of money for a lot of unutilized features
×
×
  • Create New...