Jump to content
SAU Community

Recommended Posts

100_2764.jpg

I have for sale an unfinished project. It is registered in NSW till May and completely drivable and reliable. The RB26 engine number is on the papers. Needs paint and some attention to finish off.

The car started out as a GTS-4 sedan. I have swapped the RB20det for an R32 RB26DETT

Interior

Nismo instrument cluster

Personal steering wheel

Nismo white Gearknob

Garrett Boost gauge

Engine

R32 RB26DETT

Tomei Sump baffle

Garrett GT2860-7 Turbochargers

Trust dump pipes

R34 GTR injectors

Splitfire coilpacks and new harness

Aftermarket radiator and thermofan

GTR intercooler and blowoff valves, all stock pipework

All work was done 2009/2010. New timing belt/water pump/ intake and exhaust gaskets etc

Driveline

GTS4 front and rear diffs (Higher ratio than gtr)

Exedy clutch, Nismo clutch pedal bracket and braided line

R32 GTR brakes with slotted rotors, QFM a1rm pads. Braided lines

Nismo Suspension

Rare R32 V-SPEC BBS wheels 17 X 8

What needs doing

The paint is aging, with a few bumps and scratches. The clearcoat has started to lift on the bonnet.

Some rust spots here and there.

Will need a new exhaust soonish, pipe has some rust holes

Engine covers need a repaint

I have the following to go with the car:

GTR fibreglass front bumper with mesh and N1 vents + steel reinforcement

GTR front grill

GTR rear wing

New Nissan oxygen sensors

Replacement pass side rear door

Asking $8500 ono. This car will look incredible with a respray. email [email protected]

Car is located at Seaham NSW

Some pics of the build here, these are from 2010, car has aged slightly, paint has flaked off the engine covers.

http://smg.photobucket.com/user/daver31gtsx/library/HNR32%20GTS4?sort=3&page=1

Edited by Dave R31
Link to comment
https://www.sau.com.au/forums/topic/438230-fs-nsw-r32-gts4-sedan-rb26dett/
Share on other sites

Car is still for sale. Note car is at Seaham, north of Newcastle. about 20 mins from the end of the M1/F3

Also should have mentioned car has no airconditioning fitted.

Dave

  • 3 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Resizing injectors in Nistune can be done a couple of ways, and there are a couple of ways that you can make a mess of it. The tuner needs to be really aware of the effects of whichever approach he uses (either K, or TIM). They are both easy enough to "get the injector size right" to run the engine. But little details like old start enrichment and hot start are affected differently, depending on which boxes you check.
    • Pretty safe to say almost everyone that has tuned their own car has experienced this issue. The difference being that we have our laptop in the car and when it happens, it's literally 10 seconds of tuning to sort it.  Would you be happy to plug in your laptop and sort this yourself? It is a very simple process and there is no risk of harming your engine (if you are worried about that). 
    • Yeah thats the next step now, either they wil or i will take out for a drive to work and go straight their after work and see is we get the same issues 🤞  thought i try my luck here too, never know someone else might have had the same issue but thanks for the reply 
    • Basically your tuner needs to drive it for the 30 min (or whatever) to create the same conditions then check the ECU settings and sensors at that time. They may not be excited to because that takes them 30 min rather than just opening the bonnet and seeing the problem straight away.... Hot start is generally not as tricky as cold start, but there would be a table for fuel enrichment vs coolant temp as a starting point
    • Yeah, they all cant say anything for sure as everything is working fine . Said unable to find an issue untill it stops again. Could mist likely be CAS wiring or IAS valve issue but again not 100%
×
×
  • Create New...