Jump to content
SAU Community

Recommended Posts

i have a r34 gtt auto with 117k with the following list of mods

spiltfire coil packs ( have only done about 15000K)

trust turbo back exhaust

greddy ebc set to 11 psi

k & N panel filter

(stock turbo)

so basicly not many mods as you can see.

The problem is that when I start the cold start the car it will shut of straight away, I wait about 10 seconds start it again it goes up to aout 1000 rpm then down to about 400 rpm then up to 600 rpm then bounces between the 2 for a little while. I can drive the car but it seems down on power. It wanst to stall when I come to a stop at a coner but still keeps running.

I have replaced the spark plugs, O2 sensor, Air temp sensor, Fuel fiter & air flow meter.

I have also cleaned the throttle body & aac.

I am using ecu teck to check for error codes and I am not getting any error codes just the 55 code ( all clear)

need any ideas please

Edited by newboost
Link to comment
https://www.sau.com.au/forums/topic/438336-need-help/
Share on other sites

Just a suggestion as I've had almost identical issue in the past.

Check your engine temp sensor connection, (the 2 pin square plug not the Single wire plug)

If it's not connected properly it won't give cold start enrichment, it also won't throw a code.

Mine had a broken clip and was on but wasn't making contact.

Link to comment
https://www.sau.com.au/forums/topic/438336-need-help/#findComment-7184772
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Sorry, are coilovers ACTUALLY ILLEGAL in NSW? They aren't in Vic, as long as they retain 70% of stock travel and the car is above 100mm off the ground. Does NSW actually have a law making coilovers actually illegal? RWC/Blue Slip/Engineering people not knowing the actual f**king laws boils my blood. Demand them to point to the documentation that states a coilover is illegal. (it may exist in NSW )
    • But seriously, can we ask for the results of the "tip a bottle of metho into a nearly empty tank" experiment?
    • Hang on. Let me get this straight. The desire is to have coilovers, BC in particular, to be MORE comfortable on Sydney roads than stock suspension? Well, that's obviously not right. BCs have crude damping design at the very best, and typically hard spring rates. BC stands for Billy Cart. And then, the desire is to put in some shitty old worn out stockers, to get it blue slipped and then put the BCs back in? And then.....what? Not worry about getting pulled up by the Plod? Because you seem to have raised a worry about paying for engineering (which actually does solve all your legality problems) and still getting pulled up.... but the only problem there is that if/when that happens you have to show your paperwork at the inspection station. Whereas, if you just swap in borrowed shitty old stockers to get it slipped now, and then you get defected in the future, you have to go find more shitty old stockers then too. You course of action looks like this set of options: Buy brand new stock type dampers, and springs. probably cost a bit more than $1k all up, but will last for the remaining life of the car. Put them in, pass inspection, drive on them forever more. Hell, they could even be really nice Bilsteins and Kings or other lower&stiffer springs if you wanted. Get the car engineered as is. ~$1k. Buy new Shockworks coilvers (or MCA) and also pay for engineering. You're spending a lot more here. But these will be the best things that you could drive around on.
    • Might be worthwhile hitting up Facebook's groups, I know most of them contain terrible people and scammers - however you might be able to find someone that's in Sydney with factory suspension you could purchase and/or hire. Just do not send any form of money anywhere, in person cash only.
×
×
  • Create New...