Jump to content
SAU Community

Recommended Posts

G'day guys,

i just serviced my r33 93 gtst. standard service plugs filter n oil.

put it back together and it sounds like its miss firing. iv tested the coil packs one by one and its seems they are ok cause every time i pull a plug off it miss fires worse. when under load it miss fires and spatters.?

is this a sign of a dying coil pack.?

any help would be much appreciated.

Link to comment
https://www.sau.com.au/forums/topic/438866-r33-miss-firing/
Share on other sites

well check the loom.

just checked the old plugs the last service i got done the dude has put BPR6E.. which are completely wrong. They are a lot thicker. could of those plugs stuffed the coil packs?

new plugs installed are BCPR6ES.

been trying to check the resistance on the coil packs but can't seem to find if Rb25DET S1 are the same as other RB coil packs and meant to be between 0.6 to 0.9?

Link to comment
https://www.sau.com.au/forums/topic/438866-r33-miss-firing/#findComment-7193660
Share on other sites

wrong plugs won't damage the coils.

Not sure in resistance, it also doesn't seem to be a good way of diagnosing coils anyway as heat makes a big difference. clean the boots and apply silicon grease and see if that helps.

I think it's the loom though, they get heaps crusty due to the heat.

Link to comment
https://www.sau.com.au/forums/topic/438866-r33-miss-firing/#findComment-7193706
Share on other sites

If its idling fine but missfiring under boost, close your plug gap down to 0.8mm first as a test.....im guessing you used the factory plug gaps....maybe check your old plug gaps and see what they were at, most people close the gaps to help stop on boost missfires.

While there take a look around the coils for burn marks/arcing.

If you see arcing marks around coils try wraping them in electrical tape as a temp fix till you change them.

Also its good practice to use dielectric grease around the boot inner edge to help stop arcing through there too.

Edited by GTRPSI
Link to comment
https://www.sau.com.au/forums/topic/438866-r33-miss-firing/#findComment-7194215
Share on other sites

hey guys plug gap is 11mm same as the old plugs. the plug cap shouldn't matter on a fully standard car only running standard boost. should it?

also its coughing and farting on idle now then miss fires on free rev. i check coil packs n coil loom all wires are good. couldn't see any burn marks or arcing.

man this is doing my head in.

Link to comment
https://www.sau.com.au/forums/topic/438866-r33-miss-firing/#findComment-7194282
Share on other sites

got 0.8 mm plugs, tapped up the coil packs, cleaned the connectors n loom. still running rough on idle a missing under load.

i got a new fuel filter and noticed when i turn the key to acc the fuel pump stay on a lot longer then normal. even after i have tried to prime the lines 20 times.. :-/

any chance the pump is shitting itself. or is that the kind of thing that "it works or it doesn't."

Link to comment
https://www.sau.com.au/forums/topic/438866-r33-miss-firing/#findComment-7196094
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • So either way it is gearbox out and look what is wrong?  I know about the input shaft bearing. Even before swap/new clutch the it sounded exactly like this: So is that inout shaft bearing or the other was installed backwards?  And can some please tell me the part number for that input shaft bearing? The gearbox is small box from R34 N/A and number is FS5W71C. Thank you  
    • I am yet to see anyone ever regret a quaife or helical. ...other than drifting/skidpan duties. I kind of want to upgrade my factory helical with a Quaife (but really it's not ultimately that different, and is a MASSIVE UNDERTAKING), that's how good the hype is about them, that I want to try them 'just to see'  
    • D2 and Ksport are essentially the same thing and basically just generic Taiwanese manufacture. Better than ChinaBay crap, but... not top shelf. Öhlins have got to be some of the best dampers around, so likely to be a good option. It's going to get to the point though where I suggest you buy from Oz. We have at least 2x excellent options here. If I were you though, I'd be talking to KW about doing something for the R33. There's bugger all difference between that and the 32. In GTR land, anyway.
    • KW only offers a set for the R32 GTR. Popular options are D2 racing, Ksport or Öhlins. I have a D2 Racing coilover set, though I don't know for sure which one.
    • Well, the good news is you have more than one very good option for new coilovers in and around your country. Worth the drive over to KW to talk about GTR stuff.
×
×
  • Create New...