Jump to content
SAU Community

Recommended Posts

Time to move on, so here it is :

I've had this car for 5-6 years, the previous owner spent well over 50k on this build just before moving over seas and me purchasing it, and I've put ten of thousands into it since then..

engine was built by Nisspeed in Adelaide and now has 35k kms on it. Runs 600rwhp on 98 @ 1.8bar

HKS step2 2.8 stroker, full counter crank and rods kit, CP pistons.
Brand new head from Nissan, Jun 272 in and ex cams, 10.8mm(?) lift, special retainers and all the jazz needed to support the cams and high revs, heads extensively ported.
Big dollar hypertune plenum and single throttle body setup
Custom alloy breather tank etc
Jun oil pump, N1 water pump,

ATI balancer

Trust sump extension.
Garrett TO4Z turbo and big Turbonetics external gate
OS Giken 2 way front diff
OS Giken cross mission 5spd gearset with input shaft 800+hp rated, and Billet centre plate, Less than 5000kms old
Nismo Super Coppermix spec C twin plate, less than 5oookms old, gearbox, clutch and rear diff just cost $10k plus
Nismo GT pro 1.5 rear diff less than 5000kms old
wastegate plumbed back into HKS 4inch exhaust
Huge alloy PWR radiator,

disgustingly thick Trust Spec R intercooler 160mm
Fuel system to cater for 1000hp+, in boot setup as in pics, new fuelab 1500hp variable speed pump, all E85 compatible
1000cc HKS injectors,
HKS fuel rail 11mm

Teflon braided fuel lines
splitfire coilpacks
Motec M800 ECU + Loom + Sensors

HKS coilovers
V-Spec Brembo's rear, K-Sport 8-pot 356mm fronts with new rotors
Midnight purple paint in excellent condition. Will try and get some pictures with better light to show off the purple.
Excellent condition original interior with almost no wear in the usual places (seat bolsters, etc)

Custom Air/con system, to fit with big intercooler, radiator and oil cooler

Fullrace ETS pro Attessa computer. Complete stand alone unit that enables you to control the 4wd from 0-50/50 split and RWD mode.

Series 3 Zenons
Silly money spent NO EXPENSE SPARED ON THIS BUILD. $38k ono

Richard 0411861466 WA

post-48287-0-51161200-1411891955_thumb.jpg

post-48287-0-80569200-1411892029_thumb.jpg

post-48287-0-45769700-1411892076_thumb.jpg

post-48287-0-18106200-1411892140_thumb.jpg

post-48287-0-46169900-1411892180_thumb.jpg

post-48287-0-88822400-1411892242_thumb.jpg

post-48287-0-01830500-1411892687_thumb.jpg
post-48287-0-13585100-1411892846_thumb.jpg

Edited by tricstar
  • Like 1
Link to comment
https://www.sau.com.au/forums/topic/449131-midnight-purple-r33-gtr-28l-600rwhp/
Share on other sites

  • 2 weeks later...
  • 2 weeks later...
  • 2 weeks later...

Guy got a bargain. Would've liked a bit more. But we're only talking a few grand. Sorta glad it's done, now I can concentrate on other things.

Got a GTSt that I'm striping out for a track car, so I'm not gone.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • sold listed as a Tomei LSD 1.5 Way For 1998+ Nissan Skyline ER34 25GT RB25DE w/Open R200 https://www.ebay.com/itm/174006114594?campid=5338967980&mkevt=1&mkcid=1&toolid=10050&customid=&mkrid=711-53200-19255-0&loc_physical_ms=108689&loc_interest_ms=&campid=5338967980&mkevt=1&mkcid=1&toolid=10050&customid=71883f2ccc571356e0a757bc7adfdde2&mkrid=710-53481-19255-0&loc_physical_ms=108689&loc_interest_ms= it went in like butter all gears, alignment, back lash etc, rotation and clearances correct, and if rolling all rotates smooth and free when coasting down road , clutch in or out over 10 mph smooth... its the binding, clunking and jerking from a stop that is most concerning, also seems like its going to tear the tires off in 10 miles of normal road driving. 
    • What 1.5 way? There's no such thing really as a 1.5 way, just different ways of explaining 2 ways with different ramp rates. HOWEVER. In any driving in a straight line your 1.5 or 2 or 1.7 way should have no clunking at all. With the clutch fully depressed the diff should be silent (unless it's welded but I'm assuming it's not). Something aint right here.
    • Clutch is a spec brand, new clutch system,( PP, flywheel, friction disc, etc. pull type) installed 100 miles ago, with no problems.
    • looking for some help and maybe some insight on others experience with a new LSD. R34 GT ran and drove beautifully, but always alot of grip loss due to the open R200 rear end, so I just installed a new 1.5 LSD way into the stock open R200 for a ER34. Simple. Everything seemed right. I test drove for the first time this weekend. as I started to back out the garage the first time slowly with tires straight it sounded and felt like I had a loose or half disconnected drive shaft...that was clucking around loose and shaking entire vehicle, and making it feel like the trans clutch was spontaneously slipping then grabbing very roughly while just letting out pedal slowly. I backed it out went to pull forward with the same noise, shake and slip grab feeling with hesitation, I turned the tires to back out more and then pulled ahead some same thing but worst because of added wheel resistance (which that I expected) puzzled … pulling it back in checking everything over and finding nothing wrong, I tried it the next day. same thing, couldn’t believe how it shook everything again making a terrible noise and making it feel like the trans clutch was slipping and grabbing, but I got it out of garage into the driveway, got it straight, drove forward and then reveres a few times in a straight line everything shaking , causing what felt like clutch slip and grab every time, sounded like right behind front driver tire and I could feel it in the floor board with my feet,... worst right when beginning to let clutch pedal out to engage slightly, shuttering and sounding terrible along the way…I managed to slowly get down the road, babying it the whole way, once I was rolling (out of 1st) seemed to be better and between shifts, then clutch felt closer to normal…not slip/ grab etc., but back down to any stop, straight road or turning, same thing. Made no difference if all tires were straight or if I was turning. All other gauge read out correct. with in 2 miles as planned I reached the empty parking lot and performed the break in procedure that came with lsd, essentially to drive in a figure 8 a bunch.  Did this, binding chattering, and shaking the car the whole way. I drove it back home seemed somewhat normal once I was in straight line and past 10 mph or so, and I know it will “bind” on corners and cause some tires squeal when turning especially from a stop, but when I begin to move it still causes what feels like the trans clutch to slip and jerk badly as well as shaking the entire car, and sounds terrible, that I didn’t expect. I used the fluid they supplied with LSD kit and did the breaking, planning to change fluid as they suggest after breaking, but wondering will it get smoother or less aggressive with use? maybe a 1.5 is just too aggressive for normal road driving?   I have a LSD that I put in my 71 cuda when I restored it, with amazing smooth , quite yet effective results. Different style LSD but that ones a joy to drive. maybe expecting too much from this R200?
    • Join SAU NSW for a flame-grilled feed & flame-spitting cruise! Sunday 17th August 2025 3:30PM Meeting Archies Flame Grille Sylvania Waters 4:45PM Cruise Departure 5:15PM Arrival at Cape Solander Kurnell Meet Location: Archies Flame Grille Final Destination: Cape Solander Kurnell *Disclaimer* There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU NSW and thus, treat others accordingly. • Any misbehavior will not be tolerated and you will be asked to leave.
×
×
  • Create New...