Jump to content
SAU Community

Recommended Posts

2003 BA Falcon XT Wagon

Automatic

141000kms, regularly serviced with log books

New Air con is nice and cool!

New Brakes

Full rust proofing

11 Months Qld Rego.

18 inch ARK wheels optional (+$1000)

Will come with standard wheels with roadworthy tyres.

Perfect family troop carrier, car is currently located on the Gold Coast.

Rear seats have hardly been used as car was previously a company car.

I am looking to downsize to an Import sedan or wagon.

Will consider swap for Nissan Stagea WGN34 NM35 Toyota Chaser Mark II IRV Caldina or Subaru Forester XT Liberty GT or Nissan XTrail.

Price: $6,791 ono

All enquiries to 0410 583 744 or [email protected]post-24827-14315836436657_thumb.jpgpost-24827-14315837499675_thumb.jpg

  • 2 weeks later...
  • 1 month later...
  • 2 weeks later...
  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Not sure the US can import anything other than the C34 Stagea's, but if you can and you need to to tow, DO NOT under any circumstances get an M35 Stagea. If it is just as a family car and your country/state allows it, absolutely and definitely get an M35 (3.5L if possible as it is effectively a 350Z) over a C34.
    • Punch your VIN (nm35-xxxxxx) into Amayama.com You can see everything there quite easily.
    • Thanks for that, I'll check it all out. I can always do the brakes last anyway if its a problem.  The 16's are super cool, if they do fit I'll cruise around with them for a bit.  
    • Well, that's kinda the point. The calipers might interfere with the inside of the barrels 16" rims are only about 14" inside the barrels, which is ~350mm, and 334mm rotors only leave about 8mm outboard for the caliper before you get to 350, And.... that;s not gunna be enough. If the rims have a larger ID than that, you might sneak it in. I'd be putting a measuring stick inside the wheel and eyeballing the extra required for the caliper outboard of the rotor before committing to bolting it all on.
×
×
  • Create New...