Jump to content
SAU Community

Recommended Posts

I'm sure everyone knows about this site but in case you do not please enjoy some BNR32 and BCNR33 fully refurbished car pron:

http://garage-yoshida.net/car.html

I'll do my best to visit them in April/May and if I do I'll make sure I post some more pics.

  • Like 1
Link to comment
https://www.sau.com.au/forums/topic/461788-yoshida/
Share on other sites

I'm sure everyone knows about this site but in case you do not please enjoy some BNR32 and BCNR33 fully refurbished car pron:

http://garage-yoshida.net/car.html

I'll do my best to visit them in April/May and if I do I'll make sure I post some more pics.

My car is there now getting some stuff done before it gets shipped over here.. His attention to detail is unreal!

Link to comment
https://www.sau.com.au/forums/topic/461788-yoshida/#findComment-7656158
Share on other sites

My car is there now getting some stuff done before it gets shipped over here.. His attention to detail is unreal!

This is not your car getting "some stuff done" is it ;)

http://blog.garage-yoshida.net/wp-content/uploads/2013/05/IMG_8000.jpg

Link to comment
https://www.sau.com.au/forums/topic/461788-yoshida/#findComment-7656654
Share on other sites

This is not your car getting "some stuff done" is it ;)

http://blog.garage-yoshida.net/wp-content/uploads/2013/05/IMG_8000.jpg

Haha god no... My car has zero rust, it's just getting the seats refreshed, new dashboard, replace bushes etc

  • Like 1
Link to comment
https://www.sau.com.au/forums/topic/461788-yoshida/#findComment-7656721
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • R34DE as in R34 with an RB25DE? So did you get this? Or you planning to?  I'm not really sure what you're saying. 
    • Possibly avoid using a Cometic one unless the deck/head surface are perfectly flat. I did have a look just then and forgiving gaskets such as Tomei or Nitto don't exist for the FJ20, however the Bar-Tek or Kameari ones look good and might do the trick.
    • Because pipe threads for pipe things. M threads for bolt things. Throw some teflon sealant onto it and dust your hands off knowing you did the right thing, instead of going twice around the block to achieve a result using the wrong things. Of course, all of these solutions are ignoring the fact that the minimum thread pitch we're talking about here is 1.25mm, with the 1/4" in NPT or BPS being out around 1.4mm. You will need to know that the boss you're tapping has enough thickness for at least a few threads. That's one of the reasons that 1/8" is commonly used - because the pitch is <1mm. And why would you look to use 1/4" NPT in a BSP country anyway? Ugh.
    • Just throwing around ideas, does it need to be in the compressor cover? Why not the hot side piping?
    • 1/8NPT drill size = 8.7mm. Since the hole got messed up by me, it’s probably around 9mm.    So 1/4” NPT would be next step. A drill size of around 11mm would be preferred there which is not way of my M12 (drill 10.5mm and tap M12 threads) 
×
×
  • Create New...