Jump to content
SAU Community

Ssr Sp3

Kmac92

By Kmac92,
in Cosmetic, Styling & Respray

 Share

Recommended Posts

Kmac92 Enthusiast

Kmac92

Posted
Posted (edited)

Anyone got these on there 34gtt, 2door?

If so what sizing/offset did yas go to;

-Clear calipers

-Not hang out side of guards too much

And did you roll the guards at all?

Looking at purchasing a set but as they are pretty much made to order i cant really trial fit any.

Cheers :)

Edited by Kmac92
Link to comment
Share on other sites
GH05T Grand Master

GH05T

Posted
Posted

surly you would just to go the skyline wheel offsret page and work it out from there. choose the face with the backspacing to suit?

very unlikley you will get the perfect answer

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Latest Posts

    • Duncan
      Rear Main Seal (RMS)

      By Duncan · Posted

      6.3-8.3nm....pretty damn light those fine m6 threads in the aluminium retainer plate are very easy to strip
    • ev1r34
      Rear Main Seal (RMS)

      By ev1r34 · Posted

      What are the torque specs for those 6 bolts on the retainer plate and 4 oil pan bolts? I'm currently tackling this job during an auto to manual conversion... I thought this would a 5 minute job! 
    • Desean Strickland
      Forged piston skirt coating or no coating?

      By Desean Strickland · Posted

      Tryna decide if I should get a skirt coating on my cp 2618 forged pistons that im about to order. Anyone have first hand experience with a forged RB with coated or non coated piston skirts? Is it worth it and does it make much difference? And for people who went with 2618 pistons with no skirt coating how long has your engine lasted? The engine is an rb25/30 and main concern is  that It will be a daily car and will probably see a fair bit of short distance driving, have been told by my machine shop and my tuner that generally a forged engine lasts around 40,000kms before needing a rebuild. Would a skirt coating make much of a difference? cheers 
    • MBS206
      Can anyone shed some insight on this Turbo?

      By MBS206 · Posted

      From now on read it as minus 5 and minus 7 instead of dash, and you're correct...
    • XoRoKu
      R32 GTR fuel gauge not working despite fixing fuel level sender

      By XoRoKu · Posted

      Opened up the cluster to inspect the gauge itself for signs of damage and it looks good. Got curious since that needle doesn't go back to a "neutral" position by itself (it stays in the same position when ignition is off. so I manually moved it to 1/2. Connected it back, turned on the ignition and the needle started moving up! Not sure what's up with that but before that the needle was way down below empty like fully south west. There's always a chance that the needle moved slightly the first time I tried and I didn't notice because of how slowly it moves and how far it was from the markings. I don't know if the current needle position is accurate so I'll fill it up and see where that brings it. I guess I'll try to adjust it manually if it doesn't get to F. Looks like the needle position is relative and not absolute? Thanks all for your help and patience!
×
×
  • Create New...