Jump to content
SAU Community

Recommended Posts

05 M35 Stagea

Need help with suspension in my 05 Stagea. It's a Autech, axis, 350. Rwd

I can't find the answers I need and the posts are like 8 years old...

I would love to put an air ride kit in it. But I suffer the same problem listed in the old posts on here.... " A Nissan what"?

MrM35 if you see this I need you lol.

Can I use a 350z kit?

What can I match parts to?

Thanks in advance. 

 

 

DSC_0150.JPG

Edited by Long and low
Spelling
Link to comment
https://www.sau.com.au/forums/topic/471619-05-m35-stagea/
Share on other sites

AWD g35/v35 for complete set is the same.

The rears are the same as g35/v35/350z

The front is different to accommodate driveshaft

Note that weight of vehicle and front to rear ratio is differentalso...if necessary for airbag suspension. Coilovers also don't work on the rear.

 

 

Link to comment
https://www.sau.com.au/forums/topic/471619-05-m35-stagea/#findComment-7845425
Share on other sites

It depends if currently the front struts have a fork at the base which connect to the lower control arm (350z) or (like on mine) the bottom of the strut is connected to a curved section of metal which then connects to the lower control arm

Link to comment
https://www.sau.com.au/forums/topic/471619-05-m35-stagea/#findComment-7845499
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I'm with you here. It's either loom has an issue, OR, injectors are not functioning properly. It could even be they're just constantly dribbling, hence the wet, but not firing.
    • Depending on how long the car sat it is very possible for injectors to be stuck open or closed, I'd get them cleaned and flow tested. Other than that, obviously when the loom changes and the car doesn't start any more....the loom is suspect so some tracing / comparing may be required
    • Harness is for a s1 Rb25det, and it is engine and lower harness.  the old harness had broken off plugs and was in very rough condition/exposed wires and splices etc. it is not able to be put back on the car, I could visually inspect to see if they had rewired any pins on the ecu plug. The fuel pump definitly isn’t turning off it’s an external pump and very loud you can hear it. Will look at the other harness tonight, am also going to pull the fuel rail and watch the injectors spray, will update here with what I find. Pretty sure at this point it has to be something to do with injectors because car will fire up on starting fluid and cas is clicking the Injectors. Fuel pressure is steady 43psi 
    • Check the injectors flow evenly, and are actually flowing what you and the ECU think they should be flowing. If it's starting up on starter fluid, you have a fuel issue. Is it possible under cranking your fuel pump is turning off?   The harness you replaced, is that the whole engine harness? Do yourself a test, and drop the old harness on and plug it into the Z32 ECU. It's possible they've wired things different. From memory S1 to S2 is different in RB25 and you may have a wrong loom
×
×
  • Create New...