Jump to content
SAU Community

Recommended Posts

Ferni,

That comparo wouldn't be very accurate...

A stock R33 GTS25t is a lot heavier than 1340kg. The "dry" weight listed in the Nissan books (I've got them) is 1370kg for the manual and 1390kg for auto. I weigh bridged mine (manual) and it was 1455kg with 1/2 a tank of juice.

A wet weight R33 GTS25t is at least 1430kg with minimal fuel on board. The extra 90kg would make a significant difference on the drag strip.

A 1340kg (2950lb) 240SX, add fluids (30kg) and driver (say 80kg) ='s 1450kg (3200lbs)

I would say, going off my results, that a 3200lb 240SX with 290-300rwkw (Dyno Dynamics) should run into the mid 120mph range. Be interesting to see actually!

How long till it hits the drag strip underground?

It weighs in at 3100 w/ fluids and myself...

Keep in mind, this car has undergone quite a few weight reduction mods...

I will be hopefully hitting the drag strip once I put new axles in it...

I have gone through two sets of axles as the factory ones wont take the beating...

I expect the car to run high 11's on 15 PSI...

which dyno's are right i hear ppl getting different readigs from different dyno's, which one is right?

there is not really a 'right' dyno, they are all just used relatively, some read higher some read lower.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • If it (the code) wasn't still current, it should have gone away by itself by now. No, nothing it 10/10. But it is quite likely. Everything else to do with the ignition could still be responsible (which is wires and connectors). The car is an old piece of shit now, so all the wires and connectors are also old pieces of shit.
    • Lock me in mate, although I'm not sure if I'll be heading up from Goulburn or down from Sydney, either way, return will be back to Goulburn 
    • Sounds good, we will aim to be there! @The Bogan I'll give you a shout if you are heading up to campbelltown for the meet too.
    • Before I get to the test day, just to finish off the android head unit. This is a demo from car start up....the standard/host system takes a few seconds to boot (same as all v37) but Android comes up quickly. In this vid I'm using the delivered launcher but have set the default to Agami since which is easier to navigate when if use primarily 5 apps. You can see the host system still takes over when required eg putting it in reverse, and you can switch between Android and not by holding the back button 3 sec. It is pretty responsive (fast) but you can see I had to press harder than expected a couple of times.  I still have the phone connected to the stock system, and that also seamlessly takes over Android music playing. v37-android-demo.mp4 The bigger reason that I put this in though is so that I can use Ecutek directly on the head unit. That gives me a dash with logging (up to 20MB only), high and low value warnings on any parameter etc etc. I've run a USB cable from the Ecutek OBD dongle to a USB input on the unit, easy. v37-ecutek-demo.mp4   The unit did freeze on the launcher the other day, I think Agami was trying to verify the license when it didn't have a data connection...will monitor and report back if there are any other problems but so far I'm very happy with the upgrade.
    • Nah that is just crappy GPS mapping, I did have a small excursion (cold tyres, damp track, surprise!), will post up that when I get a chance.
×
×
  • Create New...