Jump to content
SAU Community

Recommended Posts

On a 2 litre, yes.  Listen to Roy.

TD06H offers a fair bit more turbine flow than the TDO6S or TD06SL2.  Impeller sizes are roughly 67, 64, 61mm.  The bigger impellers will require more gas flow to get them accelerating.

 

22 hours ago, Mayby4 said:

I know the longer runners on the standard manifold work great for a street car with torque lower down being better, But I was hoping for slightly better response from shorter ic piping and lower temps as it is a track only car.

and it makes everything so much easier to work on.

I assume the TD06H is a no go due to response?

What DaleFZ1 said. With a small pot 6 cylinder you dont need the TD06H turbine flow to max out the 20G compressor.

 

I hear you re ther inlet manifold, I ran a Plazmaman and it made more power longer up top but that was over 7,000rpm or something. So is a little disingeinous for me to say it 40rwkws more at 8,000rpm. But it did....but also cost 25-30rwks through the mid


gallery_462_50_44142.jpg

 

Strangely the car lost top speed down the straight at PI as it smply didnt have the pull in top of 5th even though i was raping it hard into 8,000rpm in 4th before shifting. I was frustrated as the car struggled to pass a 135i with exhaust as according to data i lost a bit on the straight and a few corner exits but gained at a few others. If I had my time again I would go std...which funnily enough my current motor has RB20 architecture and I now run std inlet

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...