Jump to content
SAU Community

Recommended Posts

Hi.

What functions can I access with the dagalogit that I can't access with just the handcontroller?

I don't think that's the point of the datalogit... The point is have you tryed to setup a whole fuel map or ignition map using the hand controller? The datalogit allows you to setup the whole map at once instead of having to view the map in sections like you do on the hand controller. It just makes tuning a lot easier vs. the hand controller. I'm sure there are other uses for it but i believe that is one of the main reasons people use it.

Link to comment
https://www.sau.com.au/forums/topic/64327-fc-datalogit/#findComment-1205816
Share on other sites

Advice--

Go to the FC-Datalogit website, this IS all explained..

There are some settings like temperature settings that can't be fully set with the hand controller, instead with FC-Datalogit, you can drop these values.. FC Commander can drop the fan turn on tmep to 95 deg, where as with FCDatalogit you can go below 70 deg.

You can also hook up launch control for 0 km/h rev limiting.

Go to the website it is all answered, all explained..

Link to comment
https://www.sau.com.au/forums/topic/64327-fc-datalogit/#findComment-1206446
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Mixing things up - installed some leather recaros to match the leather seat covered rear seats. Interior looks pretty schmick now except for some slight wear on the steering wheel which I will monitor and address if it becomes worse or actually noticeable!  
    • Didnt realise RB's had more then 1 head.
    • I'm normally copping my own abuse from neglecting my daily drivers. "Those suspension bushes will last a bit more", "Don't worry about the oil leak, just keep topping it up". The project cars I'm always doing things slowly on them as I'm wanting them to be done better, and neater, and nicer. Luckily I don't have to deal with 18 year old Matt's "Learning to wire" stuff in the project cars. And there's only one piece of wiring I'm displeased about in the Landcruiser, and it's about to be cut out... However, the box loads of parts that have been going through this place lately for the Landcruiser... Brake pads Brake Rotors Full handbrake overhaul Wheel Bearings Seals Swivel hubs Steering Boxes Half the suspension joints Shocks Air bags (Ones to go in the rear springs for towing) Water pump Timing kit Lower timing case Harmonic Balancer Radiator Lots of other little seals and shits Gas struts for the bonnet New power window switches And god knows what else I've forgotten... Ha ha ha I have my fingers crossed the pinion seals don't start leaking on the diffs, that the transfer case doesn't leak, and the gearbox input shaft doesn't leak, nor the rear main seal. As they're about the only seals I haven't replaced in the driveline! I'm seriously eyeing off buying new caliper rebuild kits front and rear brake calipers... I'll probably recheck all the valve clearances soon too, and hopefully, it should be all good and sweet to haul some long distance trips again!
    • Every time I pull my 3x gauges out of the console and see the crack-addict way that I did the wiring, and I just can't bring myself to tear it all apart and "make it nice", because it is currently working. In fact, the last time I was in there I probably made it worse.
    • The best part is when you own the car long enough that you look back and find your OWN ham fisted amateur shit!
×
×
  • Create New...