Jump to content
SAU Community

Recommended Posts

heya

i've recently lowered my car on stock shocks

it handles great on wet roads

however, as it has recently rained, i found out that the tyres no longer grip the roads properly and that basic accerlerating, bumps on the road or turns would result in a bit of sliding of the wheels. sometimes it feels like i am hovering ?

this is very scary and i've lost confidence in the car

before lowering, the car handled great in the wet

could this be a result of lowering?

maybe i should revert back to stock?

oh, also, i've found that the tyres have been covered with some blackish substance which has left a mark on the garage floor. Could this contribute to the slipping and sliding?

anyone have any advice? i'm feeling a bit down right now =(

Link to comment
https://www.sau.com.au/forums/topic/65228-result-of-lowering/
Share on other sites

Here's the correct camber/tracking details for a GTT. Mine had twice angle it should have (after lowering) but there is an offset adjuster built in to the standard suspenion (rears only) so you can alter it back to normal.

http://www.r34gtt.net/r34tracking.jpg

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Working through possible solutions of converting my mechanical speedo.    Anyone know what type of speedo sensor the factory r34 gtr getrag has ? what the output is ? I assume its not a VSS and more a voltage like earlier speedo sensors ? Can an ECU read it ?  
    • roof rail delete used to be a thing, they were made locally for a while too
    • I can get more photos of it here soon and I plan to make a thread detailing the process. I received the car this way and it sorely needs refinishing. That is probably the most appealing photo of it. Up close it is fading, cracked, and needs to be re-glued. Depending on their condition I'm on the fence between refinishing or making a new set.  Another angle hiding the pimples and razor pumps  
    • According to this thread the RS4V with build plate RC40 comes with the R200 diff @ 4.083 ratio as well (mine has said RC40 denotation). We may need to check if the axle stubs are the same pattern as well. The auto subframes have longer axles. However I think yours being a later Series 2 as well, we should have the same bolt pattern for the diff stubs. Unless your upgraded rear also has upgraded axles. Either way, I would not be opposed to pulling the covers to check so I can inspect that  fancy rear core  Also I don't have HICAS. I don't believe that should change things but I hope the people here with heaps more experience than me can correct me if I'm wrong   Let me know if you want to attempt to make this work and I can get some pictures of mine from under the car. 
    • It's not that straightforward. For example I have had this code because my ignitor/power transistor wires were unplugged. It knows something is wrong but has no idea what it means. If you want to actually diagnose this I recommend following the service manual flowchart for code 21. Ohm out the harness, coilpacks, inspect the ECU, etc. And again, it's entirely possible for there to be no problem at all but if you're running a different coilpack it'll trigger the code because it doesn't like what it sees.
×
×
  • Create New...