Jump to content
SAU Community

Recommended Posts

I'll be there - hoping to lower my PB to a mid 13 (or thereabouts) from the 13.9 I did a couple of weeks ago before the car was tuned. Traction will be the issue though - damm Falkens! :)

It would be good to get a heap of Skylines out there on the night and hopefully the weather is dry and cool(ish) - looking forward to it.

Link to comment
https://www.sau.com.au/forums/topic/65764-wsid-2305/#findComment-1228671
Share on other sites

it will be fine :rofl:  

http://mirror.bom.gov.au/products/IDR032.l...oop.shtml#image

I will be spectating.

Yeah, the radar looked ok mid morning, but it's not looking so promising now...there's rain areas popping up everywhere :rofl:

I'll check it again in an hour's time, but if it's not looking any better, I'll probably give it a miss and look to get out there next week instead.

Link to comment
https://www.sau.com.au/forums/topic/65764-wsid-2305/#findComment-1233833
Share on other sites

Outdoor temp here is 22.4c

This time the last 3 meetings its been up around 28c which means hopefully it will be under 20c by the time racing starts :rofl::)

Now all I have to do is workout a way to get my jack/wheels there :rofl:

Link to comment
https://www.sau.com.au/forums/topic/65764-wsid-2305/#findComment-1233905
Share on other sites

Sorry guys, I'm out - the radar is showing a heap of showers heading towards Penrith and I'm guessing that it'll probably continue along to WSID as well which is pretty annoying. I was keen to run tonight, but I don't want to rock up to get only 1 or 2 runs (if that) because of the rain. I'll definately be there next week though...

Good luck ben if you still decide to go tonight :rofl:

Link to comment
https://www.sau.com.au/forums/topic/65764-wsid-2305/#findComment-1233970
Share on other sites



  • Latest Posts

    • I don't care for these at all, but at least the underside looks straight and not rusty. A good basis for a long life. Many cars from Japan have been lifted with forklifts and f**ked almost irrepairably.
    • Yes, but it's not dumb or dodgy. You can build a perfectly good boost controller from a pressure reg, a relief valve (looks same same as a reg if all from Norgren or SMC, for example) and a check valve. I ran one for years. Only superceded with  EBC because I could get one for cheaps and wanted finer control.   THis mod is certainly not a sketchy boost mod, provided the boost is kept below the "spin to death" threshold of the turbos.
    • With ordering the belt, you're doing water pump and the idler and tensioner at the same time too yes?
    • This is just a dumb way of keeping the wastegate closed to make more boost. Undo it and either follow the factory setup or redo it properly. Manual boost controllers just use a spring preload to determine when to close in response to boost pressure so it no longer vents to atmosphere.
    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
×
×
  • Create New...