Jump to content
SAU Community

Recommended Posts

4sale

'95 r33 gts-t parts (series 1.5)

too much to mention

some of you would know me and the dilema's ive gone thru lately and i've given up.

given up on the r33 project and gonna be a tightass and get a 15yr r32 recently brought in

If you have a r33 gts-t and need parts shoot me a PM and an offer and i'll go thru what I have and get u a pic

Ive pretty much got it all

located in melb but will post at buyers expense for interstate interest

thanx in advance

Jay

Link to comment
https://www.sau.com.au/forums/topic/69328-4sale-heaps-of-r33-parts/
Share on other sites

  • Replies 97
  • Created
  • Last Reply

Top Posters In This Topic

By the looks of it you only just signed p at the most 4 days ago... so who knows you?

next question.... instead of listing evrything in a PM don't you think it would be easier just to post it once in this thread instead of sending the same PM over and Over again.....

I understand you have a lot of stuff for sale which is great but just write it all in here and get it over and done with :-)

as per rules post what you have and prices......

who knows me? haha when the guys i know read this they'll post on this thread dont worry.

as for the list of parts and listing them with prices...how bout i give u $20 and u do it for me...u'll be here all night

but i'll see what i can do tomorrow i could probably build 1 and a half cars with the crap ive got hats why i asked people to tell me what they need rather than listing it all :(

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Yeah well per the video it took 15s for the stock unit to start up....even if I give it a few seconds discount for starting that is at least 12 sec before you get a reverse camera if you are trying to leave a park.  The android unit is way faster, but 2016 for the stock unit is a long time ago in consumer electronics
    • Yea that’s why I said ima test them with multimeter and see the reads.
    • Only at idle. Isn’t a problem when rev it seems.
    • @Haggerty This seems silly to ask, but are you confident in your ability to tune the Haltech?  
    • Next on the to-do list was an oil and filter change. Nothing exciting to add here except the oil filter is in a really stupid place (facing the engine mount/subframe/steering rack). GReddy do a relocation kit which puts it towards the gearbox, I would have preferred towards the front but there's obviously a lot more stuff there. Something I'll have to look at for the next service perhaps. First time using Valvoline oil, although I can't see it being any different to most other brands Nice... The oil filter location... At least the subframe wont rust any time soon I picked up a genuine fuel filter, this is part of the fuel pump assembly inside the fuel tank. Access can be found underneath the rear seat, you'll see this triangular cover Remove the 3x plastic 10mm nuts and lift the cover up, pushing the rubber grommet through The yellow fuel line clips push out in opposite directions, remove these completely. The two moulded fuel lines can now pull upwards to disconnect, along with the wire electrical plug. There's 8x 8mm bolts that secure the black retaining ring. The fuel pump assembly is now ready to lift out. Be mindful of the fuel hose on the side, the hose clamp on mine was catching the hose preventing it from lifting up The fuel pump/filter has an upper and lower section held on by 4 pressure clips. These did take a little bit of force, it sounded like the plastic tabs were going to break but they didn't (don't worry!) The lower section helps mount the fuel pump, there's a circular rubber gasket/grommet/seal thing on the bottom where the sock is. Undo the hose clip on the short fuel hose on the side to disconnect it from the 3 way distribution pipe to be able to lift the upper half away. Don't forget to unplug the fuel pump too! There's a few rubber O rings that will need transferring to the new filter housing, I show these in the video at the bottom of this write up. Reassembly is the reverse Here's a photo of the new filter installed, you'll be able to see where the tabs are more clearing against the yellow OEM plastic Once the assembly is re-installed, I turned the engine over a few times to help build up fuel pressure. I did panic when the car stopped turning over but I could hear the fuel pump making a noise. It eventually started and has been fine since. Found my 'lucky' coin underneath the rear seat too The Youtube video can be seen here: https://www.youtube.com/watch?v=uLJ65pmQt44&t=6s
×
×
  • Create New...