Jump to content
SAU Community

Recommended Posts

Originally posted by HUSTLR

orange grove maccas 10-10:30

I saw your car today at West Petersham driving past TAFE

Were u in ur car by any chance...??

Car was running like a bitch yesterday.... :D

I'll might just drop by, n just hang out there, n go home afterwards.

Cars totally out of tune, won't be ready for at least another week or two.... :)

Originally posted by d.3.v.i.l

Were u in ur car by any chance...??

Car was running like a bitch yesterday.... :D

I'll might just drop by, n just hang out there, n go home afterwards.

Cars totally out of tune, won't be ready for at least another week or two.... :)

Where are you getting you car tuned???

a week or two damn!!!:eek:

Read my signature lol ;)

Originally posted by d.3.v.i.l

Hustler, Steve is coming over my house tonite to check up on my car....

So hopefully everything will be alrite for the next week.. fingers cross.... :burnout:

lol- his a car-a-holic-

He can't get enough of them lol-

I remember one day i asked him him to install a turbosmart boost control switch in my car when he has time-

Yeap no probs bring your car over my parents place and park it in the garage 11pm on a week day:uh-huh:

ok guys where the hell is this meet up maccas spot ? I cruised Cumberland H/Way both north and south of the GWH for over an hour last night with some mates and couldn't find sh1t.

?



  • Similar Content

  • Latest Posts

    • Thank you, 100% the intent. New coils were due and the 17" sixers look/feel loads better than the stock wheels. The aero options are so spot on.   Thanks for the warm welcome, all!
    • 98 r34 gtt Been rocking my latest setup and car running like never before. Have put a good 200 miles on it since all the latest changes and additions. everything is dialed in and have been driving it a bunch.   However, all a sudden last weekend as soon as I pushed throttle passed 4k and the engine stumbles, (slow or fast acceleration) hesitates and doesn’t go above 4100 or so, like a misfire. Everything else seems fine. I had a “good” set of coil packs that I removed from car when I first got it when I changed them over to new coils. I swapped out current ones for those, but no change. I also changed the plugs, no change. Seems to rev over 4 when out of gear with no load just fine no “misfire”, but as soon as its in gear with a load of any kind, it “misfires” as soon as rpm drop back below 4 k it runs perfectly, smooth, starts, restarts and drives fine as long as I keep it below 4 k while in gear. All readings look fine, no CEL   Any idea as to what could all a sudden cause an issue when pushing rpms passed 4 k?
    • When you say your cams are 272/262 is that 272in and 262ex?
    • We're arguing semantics. I am saying 45 accel and a 55 deccel ramp are "2 ways". Even a 45 degree ramp and an 89 degree ramp is "2 ways", because it is literally... two ways. The cusco 55/30 ramp is a 2 way. It's two ways. I get it though - in normal nomenclature a "2 way" would be 45/45 or 55/55 or 60/60 i.e the same locking in both directions. And something like 45/65 would be considered "1.5 way". I would then say if we're getting into the nitty gritty then every locking diff is a "2 way" diff and we should not speak in 1.5, or 2 ways but ramp angles instead. Which ofc if one of those ramp angles is 90deg, that side is not doing any locking. :p So Nismo don't obviously sell 3 things. The fact of the matter that they only sell two items really goes to show that there's a 2 way and a "1,5 way" which is really a 1 way. I believe the actual lockup for the 'adjustability' of the GT pro is really just setting preload for when the ramps actually start locking up. It's not changing how much 'wayness' there is. It is (somehow) horribly explained. People just buy whatever diff and go "locks up good bruh" and that's what ends up on socials forever.  
×
×
  • Create New...