Jump to content
SAU Community

air con Problem

TimmyB

By TimmyB,
in Tasmania

 Share

Recommended Posts

TimmyB Contributor

TimmyB

Posted
Posted

Hey guys,

Has anyone ever had a problem with their air con?

in my R32 i had to get the air con re-gassed and it works fine when it's right. But every now and then, it just goes nuts and starts blowing out really hot air no matter what the temp says, just hot. The only thing i can do is turn it off.

anyone have any ideas about what it might be?? I'm thinking it's something to do with the climate control box in the dash. It's a bit dodgey and the LCD screen does fade in and out.

Any suggestions would be helpful.

Cheers,

Timmy :(

Link to comment
https://www.sau.com.au/forums/topic/73232-air-con-problem/
Share on other sites
grandmasterb Grand Master

grandmasterb

Posted
Posted
Hey guys,

Has anyone ever had a problem with their air con?

in my R32 i had to get the air con re-gassed and it works fine when it's right. But every now and then, it just goes nuts and starts blowing out really hot air  no matter what the temp says, just hot. The only thing i can do is turn it off.

anyone have any ideas about what it might be?? I'm thinking it's something to do with the climate control box in the dash. It's a bit dodgey and the LCD screen does fade in and out.

Any suggestions would be helpful.

Cheers,

Timmy :cheers:

Sounds like the regulator mate, take it back and get them to pressure test the system and check the lines.

Link to comment
https://www.sau.com.au/forums/topic/73232-air-con-problem/#findComment-1346824
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • Manur33
      Vag Coil Diy loom wire guage selection

      By Manur33 · Posted

      Can u check this way it works for power supply?
    • Manur33
      Vag Coil Diy loom wire guage selection

      By Manur33 · Posted

      These coils draw 10amps that what i read online
    • nouveau_poor
      Unknown sound similar to BOV on positive boost with partial throttle RB26

      By nouveau_poor · Posted

      I appreciate the detailed explanation, think I understand now. I spent the better part of last night reading what I could about shuffle and potential solutions. I had replaced the OEM twin turbo pipe with an alternate Y pipe that is separated further away from the turbo. The current one is from HKS and I had a previous pipe that was separated even further away, both have shuffle. I had heard that a divider can be welded in to the OEM pipe to remove turbulence, and figure that aftermarket pipes that are more separated would achieve the same thing. From what I read, most people with -10 turbos get shuffle due to their size, though it's a bit less common with -5s on a standard RB26. I think Nismoid mentioned somewhere it's because OEM recirculation piping is common in Australia with -5 cars. It seems that the recommendation tends to vary between a few options, which I've ordered in what I think is most feasible for me:  1. Retune the MAP or boost controller to try to eliminate shuffle 2. Install OEM recirculation piping 3. Something called a 'balance pipe' welded onto the exhaust manifolds. I don't know if kits for this are available, seems like pure fabrication work 4. simply go single turbo My current layout is as follows: Garrett 2860 -5s HKS Racing Suction intake MAF delete pipes HKS racing chamber intake piping hard intercooler piping,  ARC intercooler HKS SSQV BOV and pipe Haltech 2500 elite ECU and boost solenoid/controller HPI dump pipes OEM exhaust manifolds HKS VCAM step 1 and supporting head modifications Built 2.6 bottom end All OEM recirculation piping was removed, relevant areas sealed off I'll keep an eye out for any alternative solutions but can get started with this.  Only other question is, does shuffle harm the turbo (or anything else)? It seems like some people say your turbo shafts will explode because of the opposing forces after a while and others say they just live with it and adjust their pedal foot accordingly. 
    • codygrimm27
      Can you mount the ATTESA pump in other locations?

      By codygrimm27 · Posted

      That worked out PERFECTLY! Thank you big time to JJ. He was able to swap me his stock diff. He drove all the way to me as well. Killer! Removal & install was pretty straightforward. The diff itself is HEAVY. So that’s a 2 man job.  Man does the car drive nice now! Couldn’t have worked out any better 👌
    • DannyDee2
      First time owner v35

      By DannyDee2 · Posted

      Welcome mate!
×
×
  • Create New...