Jump to content
SAU Community

Recommended Posts

My r32 which i bought 2 monts ago is bein a bitch. When i test drove it it was fine but on the drive home at about 3.5 - 4 rpm, or when i accelerated quickly or put it under load it would surge or a cylinder would feel to drop out then come back. Thinking it might be dirty fuel i changed the fuel filter. No change, we then replaced the plugs and no 4 plug was wet with fuel. No 6 had some white stuff around the coil pak which we all thought was run off from what ever the detailers used. It seemed to run well for 2 days then was back to old hat. Now it comes and goes, some times its good then itll feel really slugish. Ive ordered a coil pak from nissan to replace no 4 coil the wet plug. As its only done 74000 genuine is this a common problem or has anyone else encountered this problem before?? What else can i look at if the coil dosnt work? Any help would be gr8

Probably cracked/stuffed coil or six. This is the single most common problem with these cars I think. I have a similar problem at the moment....

Try gapping the plugs to 0.8mm instead of 1.1mm. SUpposed to cure it as long as the coils aRE okay.

If you keep getting a wet plug in cylinder 4 it will be worthwhile pulling the injectors out and getting them checked/cleaned aswell, though as has been said coils and plugs are the first logical steps.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • We used Knox Drive shafts years ago when we were doing gravel rally, good guy but I heard it had changed hands? He's got a lot of stuff and is miles cheaper than GJ and so on. He used to have a lathe setup with a MIG torch on the tool holder so he could get the uni welds just right, quite a clever guy. I just got a driveshaft done for my sequential installation and that was through Balancing Services Australia in Preston, they did the Gibson cars in the old days. New genuine CV's, billet yoke, new centre bearing and chome moly shaft was $2k.
    • Thanks for sharing that mate, I've got a couple of spares on the shelf but all the unis are tight....will give old mate a shout. BTW are you sure it wasn't just a $400 paint job? Any detail of what they replaced (cut/reweld?)
    • Yeah I saw that about the US Q50 recently, apparently it was shown to Inifiniti dealers (probably to help with their depression about the cars they can sell). Seemed like a really obvious step to me, the platforms are very similar in many ways. Even if there aren't many people who actually put the money up it should really help with image/reputation. What hasn't been clear anywhere if that is a V38 model of if they are just going to add the trans as an option in a new model year. What they did with the Z from 370z to "Z" is just weird so I'd be surprised if they released this as a V38. Great news for me to have an option; it is far from confirmed that I can get any decent track sessions through the auto so having a manual I can swap to is great.
    • I ordered it this morning, I'll disassemble it post pic's and info following delivery. 
×
×
  • Create New...