Jump to content
SAU Community

FS: Linksys and Creative


Lezzare
 Share

Recommended Posts

Creative I-Trigue 2200 Speakers

A brilliant mix of performance and style in this contemporary 2-piece speaker system brings you pleasant listening everyday. Designed to flatter your notebook, LCD monitor or portable audio device, the Creative I-Trigue® 2200 Speakers are artfully presented in subtle curves and stunning finishing. An eye-catching duo, the two speakers come with built-in 36mm NeoTitanium micro drivers and a rear bass port for impressive stereo sound quality and refined lows.

Near new condition $60 Delivered

Linksys Wireless-G Notebook Adapter

-High-speed Wireless-G (802.11g) networking for your notebook computer

-Data rates up to 54Mbps -- 5 times faster than Wireless-B (802.11b)

-Also interoperates with Wireless-B networks (at 11Mbps)

-Advanced wireless security: Wi-Fi Protected Access™ (WPA), and up to 128-bit encryption

Brand New $50 Delivered

Linksys Wireless-G PrintServer for USB 2.0 *SOLD*

Direct Deposit Preferred, but can do COD on buyer's expense

Thanks for looking.

Edited by Lezzare
Link to comment
Share on other sites

  • 2 weeks later...
  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share



  • Similar Content

  • Latest Posts

    • That's some good input mate. Nice.
    • So today I went well outside my comfort zone (again) to replace my valve cover gasket.  I have had a big leak over the exhaust leading to a lot of smoke and smell every time I drove it. The leak was in the rear driver's corner.  The job wasn't hard as such, just a bit finicky and time consuming.  The old gasket was rock hard and broken right where the leak was.  The leaky corner had so much sitting oil in it.  The good news to my amateur eyes was no buildup or sludge under the cover. It all looked fairly nice in there.   I haven't started it yet. I ran out of light and body when putting the coils and injector loom back in. Probs only 30min left for the morning.  I was so nervous putting the cover back on, I must have lifted it 5 times to make sure the gasket was still seated properly. God it's going to be nice to be leak free and not make other traffic light queuers think my car is about to explode.
    • Gave the Mazda it's first wash, it will need some clay, a light compound, and polish polish to remove a few swirl marks, but that will be a job for when I have a full day to get my DA polisher action on
    • Just did this job on my 32 with the boost doc kit. was quite simple to fit, hardest part was getting the rubber bungs back on the firewall. does anyone know how the heater will work now without the flap in the bend? Will I just have a heater on 24/7 now?
×
×
  • Create New...