Jump to content
SAU Community

plex 15th


Recommended Posts

  • Replies 261
  • Created
  • Last Reply

Top Posters In This Topic

Guest Works Auto
Originally posted by GTS-t VSPEC

I realise that Macka did a 12.98, but last week he was around the mid thirteens. If I had the t3/t4 then it would be more competitive. It was scary the way RB20LagWagon blew pass me once he found a gear.

Yeh i liked watching the baby 2L fly past its big brother too :shake: :shake: go the 20

Link to comment
https://www.sau.com.au/forums/topic/8519-plex-15th/page/8/#findComment-129969
Share on other sites

I have no problem being beaten by a better car, I'm getting used to it, it's when you let the car down that is the biggest disappointment.

The R31 is not much of a smaller cousin, big'n'boxy, but when he got the power down it sure did move.

See'ya:burnout:

Link to comment
https://www.sau.com.au/forums/topic/8519-plex-15th/page/8/#findComment-129982
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • Thanks GTSboy. I will inspect the valves actually, is this something I can do while they are still in the head? The block/bores don’t look bad to be honest hey, I can still see the cross hatches in the bores and they still measure 86.5mm. I’m not sure how to measure the installed ring gaps but I will do that and take it to someone who can. 
    • I’ve had the same headache with my lowered car, scissor jack first then floor jack every time. Ended up grabbing an extra-low profile aluminum jack (about 70mm entry height) and it finally slides under the lip without drama.
    • No sync errors , i have installed AEM disk will return original 360 slot disk and check if there’s any one with running AEM disk could share setup 
    • Its been a while! Finally thought to do something on this car, so here we go. This will be a slow burning, multiple posts as I spend 0.5-1hr a day on this job, over multiple days... Full set of GKTech suspension arms!   Step 1: Buy Arms, done! Step 2: Start removing stuff. HICAS was easy. Rear suspension arms are now gone, they were a bitch but breaker bars with long handle extensions, 2 1.5hr slots later, stock arms are off! Next step, remove the hubs and take them to work to press out the bearings and bushings!  
×
×
  • Create New...