Jump to content
SAU Community

Recommended Posts

http://insaniac.trdpower.com/sketchys-nissans2.htm

First of all, each to their own, and i dont mean to criticise other peoples cars, but this car has simply crossed the line.

Take the CA18DE out for sure, but dont put an RB30E back in! It doesnt even fit, check out the bonnet mods!

Excuse me while i go throw up.

Red17

Link to comment
https://www.sau.com.au/forums/topic/8537-one-tasteless-s13/
Share on other sites

Aww comon its not that bad, he coulda done worse and just put a sr20de in instead but he went the whole hog instead, given it coulda had a turbo on it. But im sure it will still kik some ass and at least its an individual. Woulda been a hell of alot of work to shoehorn in that thing.

Link to comment
https://www.sau.com.au/forums/topic/8537-one-tasteless-s13/#findComment-124692
Share on other sites

Originally posted by skyzerr33

heres the link

this car was at the summer nats in Canberra.

one week later it was in joondalup

with all its riceness.

http://www.pbase.com/image/10276248

gotta love the F&F sticka, the fake GTR badging and the Celica GT-4 bonnet scoop.

it look fugly

Spooted this in Rocky this arvo -- May be around for Motavation i guess

Link to comment
https://www.sau.com.au/forums/topic/8537-one-tasteless-s13/#findComment-126632
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
×
×
  • Create New...