Jump to content
SAU Community

Recommended Posts

Have a look for rust mostly.. under panels and things.. getting to the age where they can start to rust

Chasis damage underneath.

Not blowing lots of smoke

Worn bushes and suspension (can be expensive to fix if all need doing)

Oil down near where transmission meets engine (rear crank seal). Labour intensive/expensive to fix. Common problem on RB20's

Coolant system in good order

i bought mine 6mnths ago. Was seemingly in near to perfect condition, 90.000 k's and i've had to do -

air con

o2 sensor

clutch

radiator

engine seals

air flow meter

turbo blew - replaced with gt2871r in rb20 turbo housing

will be back on the road soon and will be waiting for next thing to go wrong

Anything that old will near certainly have 250,000km + regardless of what the odometer says... I would go for the latest model skyline u can afford. The older the car u get, the more its gonna cost in maintenance. I have a couple of mates with high km rb20's... they dont seem to break, just get tired! ...ie. need to crank longer to turn over, tired throttle response.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yes, I know🙄 but the sequential is not in my budget... don't want to reduce power neither, so looks like I'm stuck in the rabbit hole🤣
    • You’ll be very upset when you bust that too not to mention the gearing totally sucks. Don’t do it.
    • Is the panel filter one that is oiled? Have you ever cleaned or touched the AFM?
    • So.... the K&N air box thingo was too big, ended up gifting it to a mate, well, by gifting it he actually supplied food and beer at the pub,  which was nice, as it will not sit on a shelf in the garage for the next 10 years I did trim up some of the existing stuff to neaten it all up and gave it some wrinkle paint, unfortunately it currently has a used and abused mish mash of different types of hose clamps, 4 big fat T bolt type (shit), and a few normal clamps of vairing sizes and brands, but..... only until the 6 constant tension black worm clamps that I ordered from EFI solutions turn up next week Currently the current hose clamps are triggering me hard, LOL Is this the final version, probably not, I really want just 2 silicone pieces, a straight bit of silicone from the filter to the MAF is easy and will happen as soon as I head into Just Jap tomorrow, the problematic part is a 30° silicone bend from the MAF to the TB that I can connect the engine breather from the head, I found that there are bulk head fittings for boat bilge pumps that should work, but until I can get a 30° silicone bend the alloy pipe, and the 11ty thousand hose clamps, are there for the foreseeable future 4 hose clamps are golden, 6 are grudgingly acceptable, the 8 currently holding it all together is just taking the piss    I've also ordered 60 more retaining wall blocks for the front yard, I mis-gonculated the height that was required to get above the base of the Photinia's (red robin's) that are the hedge behind the front fence, currently it is 2 blocks high, and about 1/2 a block short, so going 3 blocks high will be above the base of the red robin's, and allow some room for mulch
    • It is the stock air box with the panel filter. Everything else is stock except the exhaust at this point, as I also went back to the cleaned 270cc injectors. I will check the RPM when the IACV is unplugged and report back.
×
×
  • Create New...