Jump to content
SAU Community

Recommended Posts

  • Replies 103.8k
  • Created
  • Last Reply

Top Posters In This Topic

  • GTS-t VSPEC

    20904

  • Nizmo

    13582

  • SHUTO-BOY

    6636

  • skyzerr33

    5353

when it just idle in my driveway (after i take it for a run and i am letting it cool down) i can really smell it :D

* Sigh *

Hi Mike.

As has been told to you by numerous people, get someone to look at it.

The diagnosis points you have given are not descriptive and definitive enough to pinpoint the exact problem ( and why would a qualified person spend hrs on here trying to anyway )

It could be anything from a faulty reg , split hose, leaking injector, filler neck incorrectly fitted ( my guess as I told you before ) , MAYBE running rich, bad plugs, and the wrath of god ( well maybe not the last one )

As has been explained to you before , rather than ask 15 different people at 20 different times , which pisses everybody off cos you get there advice and then ask someone else , go to one person , pay the money and get it sorted.

BTW if you smell fuel is cos it's is unburnt or leaking which is RICH , not LEAN.

And in case you missed the post from 2 nights ago , all ulp cars run black exhausts.

It was the lead that caused the grey colour in the pipe

Cheers

Ken

Ken- its good,im enjoying myself alot with the food and entertainment heheh. But the crazy drivers is another thing, nearly got rammed

yes read paulie's msg

That's good , when you back and are you bringing a swag of GReddy plenums with you for under a grand. lol

Cheers

Ken

Guest
This topic is now closed to further replies.



  • Latest Posts

    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
×
×
  • Create New...