Jump to content
SAU Community

Recommended Posts

Hey Guys,

I have these R33 parts for sale:

- Stock Exhaust $200

- Stock Cats x 2 (Both S1 and S2) $50each

- Stock Dump Pipe $50

- Stock cooler $100

- Stock ECU $150

- Series 1 Spolier (in black smallish crack) $200

- Sequncial BOV with fittings $150

- Apexi SAFC (Super air flow converter) $150

- Tap boost controller $70

- VL Calais stock rims x4 $100

All these prices are negotiable.

Please contact:

Jeremy 0401 670 923

Nick 0433 286 752

post-20203-1128769697.jpgpost-20203-1128769860.jpgpost-20203-1128770020.jpgpost-20203-1128770173.jpgpost-20203-1128770361.jpgpost-20203-1128770504.jpgpost-20203-1128770656.jpgpost-20203-1128770803.jpg

Edited by Nippa
Link to comment
https://www.sau.com.au/forums/topic/90392-r33-bits-n-pieces/
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Also build this EH ute with 370z motor and gearbox with a couple of turbos just for fun.  
    • Got the passenger door on plus the master cylinder and booster. Loaded up to take it home. At home, the colour changes a lot in the light.
    • Nothing cheap, but I have seen the AC Hydraulic DK13HLQ which is pretty close to what you're asking for. The problem is the hydraulic cylinder mandates that the back of the jack be a certain height and Skylines have fairly deep inset floor jack points. A more certain and cheap option is to get some nominal 2x10 inch lumber boards and have one board be 1.5 feet, the other board 3 feet. Glue it all together with lots of clamps to maintain pressure. Make two of these. The ramp suggested above is a good idea, it takes quite a bit of clutch slip to get over each of the boards. I only need the first ~1.5 inches for my low profile jack on a standard ride height car but a lowered car you want to go up to the full ~3-3.5 inches. Paint it or store indoors if you want it to last.
    • Ok. And Nistune? I read (here too) mainly on Stagea threads that it can by "turn off" with Nistune. But they say they still had the sensor plug in. Next week iam going to the Nistune(and other ECUs) tuner so i can finally make it work. I drove the car home and apart from the cut it drove great. No misfire no smoke no hesitation or rough start...so hoping it is this sensor that is missing  
    • I just stack 2 pieces of 200x50 timber on top of each other. Total length about 900mm, with the top one being a little shorter and both having a 45° angle cut on them to make the front edge a bit of a ramp. Put these in front of each front wheel, drive up on them, throw the trolley jack under. Takes 1 minute. Scissor jacks can eat a bowl of dicks. I never use on under my car unless desperate.
×
×
  • Create New...