Will These Fit ?

[stagefumer11]

http://forums.skylinesdownunder.co.nz/showthread.php?t=46754 ??

just woundering will these fit my HR30 ?

all ive been told is.... they are 145mm from the back of the side hub of the rim to the outside if the tyre.

[Adam_RSX]

Should fit fine, I run 16*7 front and 16*8 rear on the DR with a +32 offset.

Just check they have spokes that are ground out a bit so that they clear the callipers

[stagefumer11]

they came of a r31 will that change anything ?

[stagefumer11]

ah found out. they are +33. do you think that will stick out to much, the jap site for the wantabies says +22 max for DR30's or HR's

[Boof]

Best thing to do mate is go around and put them on the car and see if they fit or not, if they fit pay the coin, if they don't nothing gained nothing lost...

remeber though that the dr stud pattern is same as S13 silvia/S3 RX7's/datto's...I've got S13 wheels on my car, not quite right offset, nothing wheel spacers won't fix

[blind_elk]

Standard offset for the 30 is +25. +33 will sit in too far (although it's only 8mm, but they are wider than standard) - you run the risk of the rim catching the strut (at the front, at least).

As boof said, try them on first.

[Adam_RSX]

As I said before...

I run 16*7/8 Enkeis on my DR and they fit fine with a +32 offset

Blind Elk, standard offset of +25 isn't for an eight inch rim though is it

Stagefumer, +33 means they will stick out less than a lower offset

[DR JOSH]

I put my 9's with a +35 on front and rear and they both went on fine, the photo's in the thread of my car show it that way, how ever I have s13 suspension at the front.

I now run 20mm spacers and they sit just outside the gaurd like 5mm at most, which is gonna be fix by a gaurd roll.

So I'd say these wheels will fit no worries.

[stagefumer11]

whoohooooooooo