Jump to content
SAU Community

Recommended Posts

Item inmber 3 is already sold

1,2,4,5 still available ;)

cheers

Just sold number 5 as well...

only 1,2,and 4 left... and i have interest in all three. so if you want one please post that you will take it below in this thread and PM me your phone number:)

cheers guys.

Edited by CEF11E

would these be good enough to run the autronics or whatever engine ecu programs to tune? the ecu programs only a dos load of shit so i think it would be ok, might be interested.

r u willing to ship to perth if i pay postage?

can u send a PM reply please

cheers

Brad

  • 4 weeks later...

CEF11E,

I'm interested in:

4 x IBM 765D (selling for $100 each)

72MB ram

3GB hard drive

CD rom

13.1 TFT screen

Couple of Q's: Do these have a USB port ? Are batteries available for these ( and charger ) ? Will this run NISSAN Datascan well ? ( the real reason I need it )

Cheers.

P.S. I'm in Sydney.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Pads for R32 GTS-t, R32 GT-R non V-Spec (Sumitomo), R33 GTS-t and R34 GT-t are all interchangeable. R34 GT uses a 2x piston caliper, hence it didn't fit.
    • Checked with amayama and nope, the full S2 manual set is not available anymore. Unsurprising, but still disappointing as the ? on availability gave a glimmer of hope.
    • I've heard the Tomei USA head gaskets are decent if you want to o-ring the heads but otherwise not recommended.
    • The 296mm rotors are the R33 turbo brakes. The 310mm rotors are the R34 turbo brakes. The calipers are nearly the same, but not. They're the same caliper but the R34 caliper has longer legs so that it sits out far enough to go over the rotor. The pads are the same for both. When you say, "I bough tsome EBC"....did you just mean pads? Or rotors? 310mm rotors fit under 17" wheels. There may be some wheels without enough clearance though. I can't fit my fingers between the barrel of my wheel and the "corners" of my R34 calipers, but there is plenty of room behind the spokes. This is on Enkei RPF1. You can fit 324mm rotors inside a 17" wheel, but I'd be willing to bet that it would be close to impossible with the Nissan/Sumitomo caliper (using an adapter, of course), because the Sumitomo caliper is fatter than the Brembo caliper that is supposed to go on the 324mm rotors.
    • Hi. Can someone tell me what brakes(and mainly WHERE) can i buy brakes on R34 GTT? I bought some EBC which SHOULD go on my car(i have GT but it has GTT brakes) but it does not fit, Brakes are "too" small(296mm) Are 310mm be good or? I have 17 inch wheel so no "big boys" but for me driving i just need one that fits and i can get here in EU/Czech.
×
×
  • Create New...