Jump to content
SAU Community

Recommended Posts

Crusin around on da web and found this....The sequel 2 the original F&F is being called 2 Fast 2 Furious (highly original title!). Here is a pic of the mian characters from the movie and their cars. From what i can tell the two most indisdiguishable R the s2000 (which looks like a Barbie car) and the Rx7. The R34 isn't particularly inspiring but the Supra looks cool....thoughts????

Link to comment
https://www.sau.com.au/forums/topic/9545-2-fast-2-furious/
Share on other sites

  • Replies 41
  • Created
  • Last Reply

Top Posters In This Topic

Bullcrapola

The RX7 is the best.

Maybe its a GTT (which is still a mighty fine car)..I remember another shot which had two "R34" lookalikes, in the same paint as that Skyline...but they do look a little flat on the sides for a R

Link to comment
https://www.sau.com.au/forums/topic/9545-2-fast-2-furious/#findComment-144949
Share on other sites

i don't really care about the rice .. sometimes it looks good sometimes it doesn't ... i just wanna see how the cars are portrayed in the movie ... like in the first one .. u'd think that all u had to do was buy one of the shop and u have a 10 second car ... and it also seemed like any bogan off the street could afford one ...

Link to comment
https://www.sau.com.au/forums/topic/9545-2-fast-2-furious/#findComment-145155
Share on other sites

yeah, that movie had so much wank factor it wasn't funny. With the laptop and all the flashing rice to change the parameters.

And kids basically just hanging around doing nothing driving $50k+ cars.. sounds like drug dealing to me behind the scenes - we can't have that in a movie :D

Link to comment
https://www.sau.com.au/forums/topic/9545-2-fast-2-furious/#findComment-145616
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • Thanks GTSboy. I will inspect the valves actually, is this something I can do while they are still in the head? The block/bores don’t look bad to be honest hey, I can still see the cross hatches in the bores and they still measure 86.5mm. I’m not sure how to measure the installed ring gaps but I will do that and take it to someone who can. 
    • I’ve had the same headache with my lowered car, scissor jack first then floor jack every time. Ended up grabbing an extra-low profile aluminum jack (about 70mm entry height) and it finally slides under the lip without drama.
    • No sync errors , i have installed AEM disk will return original 360 slot disk and check if there’s any one with running AEM disk could share setup 
    • Its been a while! Finally thought to do something on this car, so here we go. This will be a slow burning, multiple posts as I spend 0.5-1hr a day on this job, over multiple days... Full set of GKTech suspension arms!   Step 1: Buy Arms, done! Step 2: Start removing stuff. HICAS was easy. Rear suspension arms are now gone, they were a bitch but breaker bars with long handle extensions, 2 1.5hr slots later, stock arms are off! Next step, remove the hubs and take them to work to press out the bearings and bushings!  
×
×
  • Create New...