Jump to content
SAU Community

Recommended Posts

while driving yesterday up the high way, my car suddenly shuttered, and pooof, a big black cloud of smoke shot out behind me, then all seemed fine, but once taking of again i wasnt blowing smoke, wasnt shuttering, but on boost the turbo would spool up as usuall, then once about 2-3k rpm the turbo spool just goes nuts, its still a smooth ride but the sound is like the turbs is gonna spin itsself inside out..

now i have a faulty silicone joiner on the i/c piping, could this of just busted??

maybe a dead gasket,

or am i going to have to burry my turbo

cheers guys

cheers guys, now the hunt for it :P

ok i poped the hood and found the internal gate had a hose blown of it.. the hose feed back to the hks ebc black box thing in the hook.. would this of caused the big smoke puff and dodgy spool up... btw i cant drive it as my dash is out :) just wana know if this could of caused it

post-10720-1132816099.jpg

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • So I ride and race motorcycles for fun and have always used a van to transport my track weapons. Figured towing a racebike with a skyline would be different and if done right could - "look fully sik" or quite cool for us grown ups lol. Pic of yours truly on two wheels I also have a trailer already kitted out to transport my bikes ...and I have a spare set of rims that match the car that I was going to rebarrel to get deeper dish at some stage but they have just been gathering dust. Sooooooo it is only logical.... Stay tuned !!    
    • If by "flap disc" you meant "chocolate wheel".... then they are OK for getting off stubborn remnants. But not for stuff with bulk depth. If by "flap disc" you meant "abrasive paint f**ker"....
    • Beauty, thanks guys, got some ideas now. I note that none of you agreed with the flap disc so that's good to know. 👌🏻
    • I had small pin holes in my glazing putty but didn't want to put more putty to not make a mess again and I put 2 coats of epoxy primer to prevent it from rust. Though you can only see the pin holes if your eyes are almost against the panel. Do you think when the 3x coats of high fill 2k primer and 2 base coats go on that it will be visible? 
    • I would soak the foam with this stuff for about 10 mins then scrape off  
×
×
  • Create New...