Jump to content
SAU Community

Recommended Posts

I have no doubt a turbo top fuel engine could be built, and probably be just as powerful, but it would most likely be completely underivable.

The existing rules outlaw a whole lot of things, including turbos.

The fuelers use slider clutches and this holds the tyres right at the point of traction limit over the full quarter. A turbo would be almost impossible to launch consistently, and when it DID hit boost, it would just break into uncontrollable wheelspin.

Pretty much the same with motorbikes. Turbos are great, but beyond a certain fairly high power to weight ratio, they just are too difficult to drive (ride) and not responsive enough.

couldnt you just take half a turbo and bolt that up to one of the engine's camwheels or something and that spin the turbo, then just feed the compressed air into the intake via an intercooler? (presuming that the ECU can handle +boost :)?

couldnt you just take half a turbo and bolt that up to one of the engine's camwheels or something and that spin the turbo, then just feed the compressed air into the intake via an intercooler? (presuming that the ECU can handle +boost :P?

yes.

its called a supercharger

EDIT:

And since I am here, could someone explain HOW a top fueler could be expected to run a turbo? Here I was thinking that heat management was a serious issue (oil and water cooled), and yet a top fueler that ejects still combusting fuel out of its 8 individual dump pipes could run a turbo.

Till I see a reasonable explanation, I'll stick to my guns.

There - my 2c, and my $2 change

Edited by ebola

The problem is getting it to spool up, and controlling boost and engine torque (drivability).

Where you have a constant speed engine under very heavy constant load like in a diesel truck, electricity generator, or a boat, or even in an aircraft, turbos work great. What turbos are not so good at is for very fast acceleration.

If your turbo takes two seconds to spool up and reach full boost, the engine cannot accelerate to full power in less than two seconds. Think about it......

The engine can NEVER accelerate faster than the turbo can accelerate.

In a car that does not really matter, even a fairly fast car.

But in a motorcycle, it sure does matter. A powerful bike may go through three gears in four seconds. No turbo can keep up with that. So turbos don't work well on powerful motorbikes.

They don't work on powerful drag cars either. Once the power to weight ratio becomes really high, turbos are more of a liability than an asset. The engine becomes too peaky and laggy, and underivable.

Even the Formula one drivers hated turbos. They were very hairy to drive, especially in the wet, and generally less responsive, and less reliable than the larger normally aspirated engines they replaced.

None of this applies to road cars, and turbos are really great on the street.

But if you were building a 5,000 horsepower car for something, a supercharged big capacity V8 would be the only way to do it.

If you wanted 5,000 horsepower for a boat, a gas turbine would easily beat anything else. But it would probably take twenty seconds to spool up to full power.

All good points, warpspeed.

Though there are a few bikes with turbos, they don't run alot of boost. Though seeing some crazy guy popping a mono at 300+ kph on a bike with a turbo.

well, I'll just say that stability wasn't great (and I *like* motorbikes).

but yes, turbos take time to spool. Though I would say an engine can accelerate faster than the turbo - it just wont make as much power.

I agree that a turbo is impractical for a top fueler (and as you said illegal).

I just don't think that it could be done, as in I think that heat woult be too much of an issue.

gas turbine..... now there's a thought. only question is how much reduction gearing would you need?

"She does 220 in first. I hate the 60 kph speedlimits though"

--another semi-pointless debatable point brought to you by the letter 'I'

  • 3 weeks later...

To raise the issue again. The purpose of a supercharger on a skyline, would be instant power correct. So the issue is how to attach a supercharger of whatever size etc (worry about that later), into the skyline system without distrupting the turbo set up. You might have to move the turbos, or maybe not. The question is how is it set up? In parallel, possible but dangerous, or can it be run off another separte system and ducted in which is possible, but does anyone know more of the technical side, on how the air flows?

  • 4 weeks later...

Haha.. gas turbine powered car? Already done! In the sixties, no less.

http://www.turbinecar.com/

Hehe.. freaking neat, I'd probably eat a frog to own one of these bad boys.

 

From Autospeed's article

"They were certainly the only cars on the road that had tachos going to 60,000 rpm."

Man... imagine the sheer AWESOMENESS OF IT

Edited by doommachine

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • You just need to remove the compressor housing, not the entire turbo. I would not be drilling and tapping anything with the housing still on anyways. 
    • So, I put my boat on a boat. First of all, I'm going to come out and say it. Why is Tasmania not considered a holy goal, an apex that all road-legal modified cars go to, to experience? This place is an absolute wonderland of titanic proportions. If people are already getting club runs for once in a lifetime 30 person cruises to Tassy then I've never seemed to see it. It is like someone replaced the entire place with an idyllic wonderland for cars, and all of the people living there with paid actors who are kind, humble, and friendly. Dear god. After doing a lap of almost all of the place I've found that it's a great way to find out all of the little things that the car isn't doing quite right and a great way to figure it all out. All in all, I drove for 4 hours a day for a week and nothing broke. I didn't even need to open the engine bay. This is by all means a great success, but it has left me with a list of things to potentially address. I also now have a 3D printed wheel fitment tool which annoyingly hasn't got any threads in it to actually assemble it. I might be able to tape it together to check the sizing I actually want to use, but it'll likely involving pulling the shocks out to properly measure travel at least at the front, and probably raise the car while I'm at it, at least in the rear. I scraped on quite a few things and I'm not sure how else to go about it. I was taking anything with a bump at what felt like 89 degree angles. And address those 10 other tasks. And wash the car. God damn it is dirty. And somehow, the weather was perfect the entire time - And because I was on the top of Mt Wellington it turns out it was very much about to freeze up there. I did something I typically never do and took some photos up there in what must have been -10 and the foggy felt like suspended ice, rather than mere fog. If you own a car in Australia, you owe it to yourself to do it.
    • Damn that was hilarious, and a bit embarrassing for skylines in general 😂 vintage car life ey. That R33 really stomped. Pretty entertaining stuff
    • Hi, I have a r32 gtr transmission. Does any of you guys have an idea how much power it will hold with the billet center plate and stock gearset? At what power level and use did yours brake with or without billet plate? Thanks, Oystein Lovik
    • Saw this replica police car based on a Mitsubishi Starion XX parked next to a 'police box' (it's literally a box) in Hirohata, Himeji City in Hyogo prefecture the other day. It's owned by Morii-san who is a local Mitsubishi Starion enthusiast. According to a local radio station blog post, he always wanted to make a police car himself based on ones he saw in his favourite Manga comics.  As it's illegal to modify a car to look like a police car and drive on the road, Morii-san tried many times to get permission from Aboshi police station headquarters nearby. They refused initially by after they got tired of that they granted him permission. However, the car can only be displayed on private property and obviously can't be registered as long as the police livery is present. The car was completed at a cost of 1.5 million yen (US$ 10,000) in addition to the car cost. A location was chosen outside Hirohata Police box where the car can easily been seen from the street. Morii-san has two other Starion road cars, both widebody GSR-VRs.
×
×
  • Create New...