boomtheroom

is there a tutorial anywhere that explaind hoe to remove in reinstall the brake master cylinder on a r32 gtr with abs..with minimal fluid loss and bleeding?

m wanting to adjust the windows on my r32 gtr so they dont hit the frames when the door is closed ,and would like some owners to post pictures of where the top of the window sits when the door is closed ..to give me an idea of what height to set it thanks...

yep all been done, same components with different rotors no squeal

my current rotors are grooved...thus squealing with different calipers and different pads only thing left is the rotors

so no noise even around town?

im going to get some new rotors for my r32 gtr non brembo and have found some zonelli dimpled slotted ones..but i wan them to be quiet ...has anyone got dimpled slotted rotors that can comment?

got a part number?

i take it noone like noltec or superpro make after market ones?

just failed a warrant ...too much movement in this bush...the guy at th testing station called it a tie rod but it just a link to the bush ...my question is what is the bush called so i can find a aftermarket one for it ...its at the back next to the shock connected to the link and the hicas lock bar...will link a picture

im am wondering if anyone has had experience in adjusting or reinstalling the window guides on a r32 coupe... the problem i have is getting the angle right so when the window is fully up you can close the door and the window tucks under the lip at the top of the door mine keeps hitting it unless i close the door with my hand on the window itself angling it to tuck under the lip.. there ar 4 adjustment bolts 2 at the top and 2 at the bottom of the window guide rail any ideas on where they should be at ?

where is it actually located?

i might have this problem my air con is blowing hot air most of the time , then sometimes it works, i got a code 26 error a few times doing diagnostics which means pbr according to the manual, is this refering to the blender?

will what? make it better or worse?

would new engine mounts help the engine vibration or make it worse?

i jst changed my gearbox mount on my r32 gtr to a nismo one as the old one was worn, so much that the new one raised the gearbox a couple of centimetres higher than where it was sitting before, since the new install the car has been a bit funny, when your driving it is not as smooth as before ,ie feels like the whole care is vibrating more, and the cabin noise it higher from the engine running, also the turbos whistle on boost, and they didnt before,whats happened?

did u notice that the rubber in my nismo one has more like a v shape to the top, where the standard one is more flat. that v shape it causing the extra height in the gearbox i had to jacjk the gearbox abot 2 cm higher to get the crossmember to meet the chassie

have u seen anismo one compared to a new factory nissan one? is there a difference like mine?

no the part number is correct

just got a nismo gearbox mount for my r32 gtr, problem is that the rubber inside the nismo sits lower in the housing making the height of the nismo about a centimeter taller than the factory one, which causes the gearbox to sit higher and also pull the exhaust higher so now its hitting the bottom of the gearbox crossmember, anyone eles had this problem or know why its like that?

yea i see, is it a bolt that goes through the bell housing or is it just a seperate bolt especially for the bracket?

does it use a seperate nut or one on the existing bell housing?

yea but dont want to get the gearbox removed until it has to

but it wont hurt just hangin aye?

i couldnt find where it bolts onto so u just cut the hoses half way , im sure it wont hurt will it?

was under my car yesterday , and found this hanging from the top of my gearbox, not connected to anything. I assume it is part of the hicas tubing as mine has been removed from the car ,the two hoses were connected to the top of the gearbox