Jump to content
SAU Community

Recommended Posts

Selling my RB20det out of my R32 + auto gearbox

Runs fine and goes pretty hard at the moment with an rb25 highflow turbo. Potential buyer welcome to go for test drive to see the engine going nicely. Engine is currently sitting in front of an auto.

Tested good consistent compression across all cylinders recently. Other mechanic checks welcome (your expense). Can provide no other guarantees.

Engine / car was stock until last 6 months when modified carefully. It has a bit of minor blowby, as would be expected for an older turbo engine. Has done 111,000km, but fairly genuine km. Will come assembled with full manifolds, injectors, alternator, etc. NO turbo or lines, AFM and minor bits and pieces I need to transfer to the rb25.

Auto box is the rb20/25 RE4R01A -- and is exact swap into R33 as well as r32. No slipping, very good across the range. **** AUTO SOLD ****

Selling due to rb25 conversion... otherwise engine and auto has given me no problems over last 12 months.

Will not be available for 3 weeks or so, but here is a chance to test/drive it all in my car at the moment for some piece of mind. Put a deposit down, and it'll be ready for you.

Asking $600 for engine.

**** AUTO SOLD ****

rb20 ECU and engine loom may be available later (extra price will have to be decided), but will have to see what the rb25 conversion requires.

Link to comment
https://www.sau.com.au/forums/topic/103021-rb20det-and-rb20rb25-auto/
Share on other sites

Hey man, so your not selling with turbo, lines, afm? What about the loom? Im looking at putting one in my R31, so could you go into detail on what your definetly keeping, like ecu? Cheers, Todd.

Don't think I will need ECU.. Nor probably loom, as have the RB25 one, but will have to see.. So it should be enough for complete conversion into another car. Price on those would be extra to the engine itself.

Sorry I can't be more definitive at the moment, but when I know I will post up.

Turbo, lines, etc are transferring across to the RB25, as its an RB25 turbo anyhow.

  • 4 years later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yea - I mean I've seen my fuel pump which is decades old and uh, while I'm not saying this with real knowledge... but I sure get the ick at using anything in the fuel system that produced the state of that pump. Many years ago I went through multiple pumps (and strainers) before I dropped the tank to clean it out with extreme violence. I'm talking the car would do maybe 50km before coming to a halt, which resulted in me cleaning out the filter with some brake cleaner and going on my way. None of my stuff ever looked like what came out of your fuel tank. I don't think I'd be happy with it unless every single component was replaced (or at least checked/cleaned/confirmed to be clean here).
    • I'm not going to recommend an EBC pad. I don't like them. Just about anything else would suit me better. I've been using Intima pads for a while now.
    • Agreed, and in particular the earth strap that should go from the subframe to the chassis but it often broken or left off. There is a section in the R32 workshop manual you can follow for troubleshooting if you don't see anything suspicious, and depending where you are (there is no location on your user profile) you should be able to get your hands on a second hand replacement unit still if needed
    • Yeah they mention as a R34 for 2.5 Turbo...but then again thos "small" were also for R34 by that different site. But i look into it and that 310mm EBC is for R34 GTT. And by those you linked the specs are the same 🙂    EDIT: I found these on one site here: DBA 4000 series T3 DBA42304S They are 310mm...and it says are for R34GTT...are there good? EDIT2: ok they have pads too.  What "color" should i get for street use? I dont want/need some noisy ones...(and if they are not that dusty that is good too)
    • Yeah, shame. Maybe  driver's carpet is available 🙏. I am waiting for both amayama and nangun to confirm.
×
×
  • Create New...