Jump to content
SAU Community

Recommended Posts

Hi guys,

It's been a while since I got on here... life has been really hectic. Anyway, I now am in dire need of some help.

Driving into a shopping centre car park today, the head lights came on as it got dark under cover, and without warning the car immediately shut down. The alarm came on and I could not turn the alarm off or restart the car. Almost straight atway, the alarm started sounding sick, as in weird pitch shifting down, almost as if it was draining a battery...

OK, sounds like either the immobiliser/alarm has carked it, or I need a new battery, with the alternator as another possibility. Hazards on, they work, the key alert works, lights seem to work (parkers anyway).

I called the guys who installed the alarm, and since they are about 5 min down the road, an installer came out to check if it was the alarm causing the problem. He pulled out the control box and rewired it so the alarm was now removed from the system, and should work normally.

Tried to start, no luck. No lights on the dash, the engine doesn't turn over or anything. Hazards etc still work.

Replaced the battery, and same deal! No dash lights, no activity from the engine bay.

Now, please help me with my logic here. I have checked relevant fuses, there is a new battery, and the alarm is (supposedly) out of the picture.

What the hell else could this be?? The car is still in the car park, and I have a massive weekend of work ahead, so I really need to get this sorted today if I can.

Thanks in advance guys.

Link to comment
https://www.sau.com.au/forums/topic/104371-help-no-power-no-dash-lights/
Share on other sites

Previously ive had an issue with a friends car where the ignotion relay was stuck open or closed, swap the relay in the bonnet around, maybe take on from say... the sunroof/rear boot or something useless and put it in the IGN place.

Just a thought, worth a try?

Its in the box next to the battery. The big blue and brown things.

A relay is an electromechanical switch, operated by passing current through a coil of wire wound around a steel core, which acts as an electromagnet, pulling the switch contact down to make or break a circuit.

The way it works for IGN is that you turn the key to the ignition on bit and the relay connects the battery with the starter motor, therefore starting the motor. Then when you let go, the key just goes back.

I am not sure, i am just suggesting from experiance.

It doesnt explain why the car just shut off though. Also, if the starter motor went the car would run until stopped, just wouldnt start again right?

Sounds like an ignition feed problem, could be the relay or the main fuse, double check all the fuses in the box near the battery with a multimeter.

The alarm would be hooked to the constant power coming into the car, sounds like you've lost that for some unknown reason (would cause the alarm to do silly things).

If it was the alternator, a charged battery would get it going temporarily, i've had that problem before.

Edited by beastien

you may have blown a fuseable link, which could have been caused by a short when the alarm shat itself...(in the engine bay...in some cases they are installed in the engine bay as what may look like a fuse and you will be able to see if its gone by looking thru the clear plastic at the top of it, but generally its just a wire you will find floating around in the engine bay, which you wouldnt be able to see if it had blown)

ive had it where it just cut all dash/lights/everything, and it was the IGN fuse in the fuse box next to the battery, it says it on the fuse box cover which fuse it is. mine ended up just being a wire under the engine shorting on the body which kept blowing it.

the fuses r available from nissan as they are special ones, not regular blade type ones.

worth a try :D

good luck

Brad

Thanks for all the help guys. I have done as suggested, and checked fuses, relays etc. I was unable to find a RELAY labelled IGN, but there was a 30A fuse in the engine bay fuse box which I swapped with another to check (both looked ok). My mate (who is an electrician) offered to help me out, and he figured out that there was actually no power getting to that IGN fuse. He hooked up a wire directly from the positive battery terminal to the terminal that fuse plugs into, and lo-and-behold, I can now start and drive the car.

It's basic fuctionality only - no accessories (air-con, stereo). Interestingly, the headlights don't work, but the parkers and fog lights do. Also, the car is permanently in 4WD, with the dash light on.

So, any ideas/wiring diagrams/suggestions out there? Obviously I am only driving the car in ABSOLUTE emergencies, and the wire is unhooked from the fuse box whenever the car is not being used.

Sounds similar to a problem I had when the stereo was installed - has anyone been near your wiring loom laterly?

My stereo installers put a CD player under the passengers seat, and drilled thru a heap of wires, ended up losing my 4wd and abs. Needed an auto-electrician to find & fix the fault.

Best of luck - brendan

hey bwilkinson,good point, i recently traced the attessa/abs wiring from the factory ecu and yes it runs directly under the pasenger seat and under the rear passenger side seats too to the back passenger side cargo area behind the side panel, so maybe someone has drilled a hole through some wiring from inside the car or underneath, or just check the last few things u did on the car (even if basic minimal stuff u wouldnt think could cause a prob) and u r bound to find something cut/disconnected. check under the ignition area firstly i reckon, and maybe its a turbo timer hooked up wrong?

good luck

Brad

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Haha, i kow right? Could have bought so many cars for the same amount of money (or less) but driving Unicorn gives you at least +1mln to style 😅. Like wise man said "life's to short to drink cheap wine and drive boring cars" 😉
    • Newbie here, proud owner of an Autech 260RS. I'm on the hunt for wiring diagrams specific to the 260RS, particularly S1. I've ran my eyes through R33, R34 Diagrams, there are some similarities, however continue to find incorrect wire colours and pins on connectors in the 33,34 diagrams.   I was hoping someone could point me in the right direction? I'd be happy to pay for the originals in Japanese. I can translate them, at least they would be accurate.   Any help please would be greatly appreciated, never heard an RB26DETT before let alone driven one, and I've got a spaghetti monster of goodness to sort out.   Cheers Benny  
    • Hey all  im wondering if you can help me please I have put a rb20 box in my r34 gtt as my auto packed up and a friend had a spare box I know it’s not ideal but it will get me up and running for now. we have done the conversation and everything is working great but my Speedo we got a s13 speed sensor but my Speedo reads double now and I bought a speed converter but still not having any luck.  so I thought I’ll reach out and pick your brains  any help would be appreciated please as I wanna drive my car again 
    • Drain it. I got official Matic D but you can get whatever is listed as Matic D compatible.
    • Thanks guys,  Yeah I should at least have them dynoed, at least then I know what I've got as a starting point.  The springs on these are hard as rocks. I vaguely remember Russman saying he was going to sell the shocks to me with the rocks fitted, as he was keeping the softer springs for his new setup.  I didn't click at the time but of course that was to let me know the shock/spring wouldn't be matched.  I also remember pricing up new springs around 2014-15, but, house, money etc. it never happened. So that was another reason to have them rebuilt. I have rebuilt the forks on many motorcycles so I think I could handle the seals on these easily enough, but getting the valving right would be a rabbit hole I cbf exploring.  Duncan, interesting to hear RP was tuning these back then. I might give them a call.  In the mean time I have been busy fitting sway bars. The Whiteline rear sway bar I purchased 15 years ago finally got fitted, along with the Whiteline front bar that showed up last week. Just waiting on new links for the front sway bar to finish that off.  And my spare set of advan AVS VS5's should be back from the powder coaters in a Pearl White finish sometime this week, with a set of Hankook RS4's lined up for fitting.  And then I just have all the suspension bushes to do. A comprehensive kit is on the way... Lots to do before the Ararat hill climb. Cheers guys 🍻   
×
×
  • Create New...