Jump to content
SAU Community

Recommended Posts

I have a turbo kit for sale off an (GTR)RB26 used for under 1000km

It contains the following:

HKS TA45 in NEW condition NO PLAY AT ALL

HKS Cast manifold (getting chrome HBC coated ATM)

HKS 50mm external gate

HKS alloy inlet pipe for 2 afm's

HKS alloy pipe replaces the alloy pipe with "twinturbo" on it and says HKS POWER

Joins the turbo to stock intercooler piping (Gives a factory fit and finish)

2 Stainless Heat sheilds for manifold and turbo will be also included just having them laser cut at the moment

Everything you need except oil feed and dump pipe.

Kit is rated at 650 HP full boost at 4500-4800 on stock internal motor with exhaust and air filter

Perfect kit for a mild but tough street GTR

Item is located in Kellyville Sydney

Price $2400

Lots more pics just look in my gallery

87.jpg

57.jpg

Edited by rx-[7]

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...