Jump to content
SAU Community

Recommended Posts

The Stagea has a vibration at speeds above around 80kmh. At first I thought it was a puncture repaired front left tyre but got that fixed and even swapped the front wheel to the back but it is still there.

Wheels have been balanced by at least 3 different places now, so not sure what is causing this. It feels like out of balance wheels but have been told it isn't, doesn't feel like an out of round wheel (my Skyline had that problem). It is a very fast but weak vibration and doesn't seem to do it at lower speeds, that I can notice.

Following a search of the threads, found this list from our guru (Sydneykid):

1. Out of balance tyres (are they balanced inner and outer? Or just one set of weights?)

2. Out of round tyres (easy to check on the balancer)

3. Out of centre wheels (do they lock securely over the hub centre?)

4. Out of round wheels (how is the run out on the inner and outer rims?)

5. Out of balance brake rotors (unusual, but does happen)

6. Worn wheel bearings (jack it up and check the movement, in and out top and bottom)

7. Worn radius rod bushes (you can see it, the rubber is torn and fluid leaking)

After that it gets obscure, eg; worn shocks can cause vibration after hitting a bump.

Therefore, should I just check each of these items in turn until find something?

Further, during my 100,000km service, the workshop noted something along the lines of front diff oil seal leaking - is this a major repair issue or just a case of replacing seals?

Link to comment
https://www.sau.com.au/forums/topic/105479-driveline-vibration-at-80kmh/
Share on other sites

mate its probably uni joints .... one has a tolerance out and is causing an unbalance vibration ... either that or you have thrown a tailshaft weight off (rare)

test by taking car to 80kms then coast (no drive) to see if it still vibrates usualy it will if its the tail shaft uni's as the tail shaft is rotating as fast as the wheels are driving it ...

Good luck!

Further, during my 100,000km service, the workshop noted something along the lines of front diff oil seal leaking - is this a major repair issue or just a case of replacing seals?

hey mate do u mean the diff front plate seal, or the sump to engine seal is leaking? the diff front plate is piss easy and the other is a pain in the arse. :P

just take front plate off, add gasket goo from nissan and put back on :(

Edited by CruiseLiner

check the tailshaft centre bearing would be my suggestion,if you've already eliminated the wheel bearings,wheels and tyres.

it's possible someone has had the shaft out before and put it back in in a different orientation. normally this won't cause a problem,but if you have a worse-than-usually-balanced shaft,it would cause what you're describing.

just out of interest,how much balancing weight is on your wheels?

if there's a lot (as in over 50grams per side),that's indicative of another problem.

Justin...

Thanks for the replies guys and it is now time to begin the hunt to determine the cause of the problem and then the fix.

Will see how it goes but at least it is still driveable

As for your question Brad, not sure as they just put it on the invoice that the "front diff seal leaking".

Sorry to hi-jack your thread, but I've got a similar problem.. I get steering wheel vibration above around 80km/h. I took it to get a balance but the guy said the vibration is because of the tyres. He said because of how the tyres have worn they are impossible to balance. He said you can try balancing them as much as you want but the vibration isn't going to go away so he'd just be 'taking my money'. He said the tread had 'feathered' and that you can tell by running your hand over the tyres. So he says I need to get new tyres to fix the problem. Could this be true or he is just trying to get me to buy new tyres??

Feathering on tyres is caused by the wheels not being aligned properly.

Get a wheel alignment done. If you buy new tyres without getting the wheels aligned, the same problem will happen and you would have wasted your money on tyres.

Thanks champ. Yea they did a wheel alignment. So this 'feathering' thing actually happens? Just get new tyres fitted and balanced and it should be good? Thanks again.

Just to add another suggestion:

Check that the casing of the tyre isn't letting go. This may show up as a deformation in the shape of the tyre - like a lump/bulge in the wall or flat part of the tread.

On a tyre on our caravan the deformation was hardly noticable at all except for the vague handling at speed.

The amount of tread left (ie age of the tyre) has little to do with it. Hitting a gutter or rock on the road may be enough to damage something internally.

If you're worried about getting had on a new set of tyres when the current tyres have plenty of life left, then keep the old set of tyres to use again later. If the new set fixes the problem then you know you can throw the old ones.

The Stagea has a vibration at speeds above around 80kmh.  At first I thought it was a puncture repaired front left tyre but got that fixed and even swapped the front wheel to the back but it is still there.

Wheels have been balanced by at least 3 different places now, so not sure what is causing this. It feels like out of balance wheels but have been told it isn't, doesn't feel like an out of round wheel (my Skyline had that problem).  It is a very fast but weak vibration and doesn't seem to do it at lower speeds, that I can notice.

Following a search of the threads, found this list from our guru (Sydneykid):

1. Out of balance tyres (are they balanced inner and outer? Or just one set of weights?)

2. Out of round tyres (easy to check on the balancer)

3. Out of centre wheels (do they lock securely over the hub centre?)

4. Out of round wheels (how is the run out on the inner and outer rims?)

5. Out of balance brake rotors (unusual, but does happen)

6. Worn wheel bearings (jack it up and check the movement, in and out top and bottom)

7. Worn radius rod bushes (you can see it, the rubber is torn and fluid leaking)

After that it gets obscure, eg; worn shocks can cause vibration after hitting a bump.

Therefore, should I just check each of these items in turn until find something?

Further, during my 100,000km service, the workshop noted something along the lines of front diff oil seal leaking - is this a major repair issue or just a case of replacing seals?

Hey

I had a similar problem with my GTR. Driveline started to vibrate on medium to hard acceleration and only when it was about 70km/h and over.

First thing to be done was the centre bearing, did look pretty worn but didnt fix it.

Wheel alignment and balance on 2 different sets of wheels. Checked all rear bushes and links.

Replaced front prop shaft as the uni joint was pretty flogged out (wasn't affecting vibration as it wouldnt make any difference with this shaft out ie 2WD).

Replaced small rubber and metal sleeve mounts for gearbox crossmember, again, worn out but didnt fix problem.

Took out tailshaft and put back in but rotated it around from original position. From what the mechanic told me there is 4 different ways for it to go back in. He moved it one mounting positon around and it was all fixed. :P

It took a bit of money and research to get it sorted for an annoying problem but probably was a good thing to get all these worn out bits n pieces replaced before they broke or caused potential damage.

Jono

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • You just need to remove the compressor housing, not the entire turbo. I would not be drilling and tapping anything with the housing still on anyways. 
    • So, I put my boat on a boat. First of all, I'm going to come out and say it. Why is Tasmania not considered a holy goal, an apex that all road-legal modified cars go to, to experience? This place is an absolute wonderland of titanic proportions. If people are already getting club runs for once in a lifetime 30 person cruises to Tassy then I've never seemed to see it. It is like someone replaced the entire place with an idyllic wonderland for cars, and all of the people living there with paid actors who are kind, humble, and friendly. Dear god. After doing a lap of almost all of the place I've found that it's a great way to find out all of the little things that the car isn't doing quite right and a great way to figure it all out. All in all, I drove for 4 hours a day for a week and nothing broke. I didn't even need to open the engine bay. This is by all means a great success, but it has left me with a list of things to potentially address. I also now have a 3D printed wheel fitment tool which annoyingly hasn't got any threads in it to actually assemble it. I might be able to tape it together to check the sizing I actually want to use, but it'll likely involving pulling the shocks out to properly measure travel at least at the front, and probably raise the car while I'm at it, at least in the rear. I scraped on quite a few things and I'm not sure how else to go about it. I was taking anything with a bump at what felt like 89 degree angles. And address those 10 other tasks. And wash the car. God damn it is dirty. And somehow, the weather was perfect the entire time - And because I was on the top of Mt Wellington it turns out it was very much about to freeze up there. I did something I typically never do and took some photos up there in what must have been -10 and the foggy felt like suspended ice, rather than mere fog. If you own a car in Australia, you owe it to yourself to do it.
    • Damn that was hilarious, and a bit embarrassing for skylines in general 😂 vintage car life ey. That R33 really stomped. Pretty entertaining stuff
    • Hi, I have a r32 gtr transmission. Does any of you guys have an idea how much power it will hold with the billet center plate and stock gearset? At what power level and use did yours brake with or without billet plate? Thanks, Oystein Lovik
    • Saw this replica police car based on a Mitsubishi Starion XX parked next to a 'police box' (it's literally a box) in Hirohata, Himeji City in Hyogo prefecture the other day. It's owned by Morii-san who is a local Mitsubishi Starion enthusiast. According to a local radio station blog post, he always wanted to make a police car himself based on ones he saw in his favourite Manga comics.  As it's illegal to modify a car to look like a police car and drive on the road, Morii-san tried many times to get permission from Aboshi police station headquarters nearby. They refused initially by after they got tired of that they granted him permission. However, the car can only be displayed on private property and obviously can't be registered as long as the police livery is present. The car was completed at a cost of 1.5 million yen (US$ 10,000) in addition to the car cost. A location was chosen outside Hirohata Police box where the car can easily been seen from the street. Morii-san has two other Starion road cars, both widebody GSR-VRs.
×
×
  • Create New...