Jump to content
SAU Community

Recommended Posts

Hey,

Last week, I have a slight problem with my battery I think. My R33 wouldn't start after 2 or 3 weeks and I had to jump it to get the car going. It's okay now, since I drive it every day. However I would like to know if it's about time to change the battery, which is purchased in March 2003.

Do I need a battery soonish? What CCA and RC rating should I be looking at? What brands do people recommend?!

Thanks in advance!!

/Andy

Link to comment
https://www.sau.com.au/forums/topic/105500-flat-battery-after-2-or-3-weeks/
Share on other sites

The higher the cranking amps, the better... although don't forget that your clock and A/C settings are always using a *little* power, and if you have an alarm, it'd suck a bit too. The ECU keeps its self-learning stuff, and i'm sure your headunit does too.. These add up, and it could drain a battery over the course of almost a month.

If you're going to change the battery anyway, it won't do any harm and shouldn't cost you more than $200 for a really good battery.

Higher CCA and higher number of plates will be the cost-factor. =-]

a good battery should not go flat in that amount of time on a stock car..

your options:

1 - as you said it could be a flat battery. theyare usually rated at about 4 years lifetime.. so how old is yours?

2 - you may have something draining power. Do you have an amplifier? neons? some other lights? if they aren't wired in properly then they could be draining power when the car is off..

good luck,

Warren

Andy, mine's just a little 330cca. My factory strut-brace meant that I couldn't run a larger battery.

By "larger" I mean;

More powerful batteries are usually bigger in physical size too. The R33 Skyline battery holder will allow two different sizes of batteries, but I had to use the smallest type to avoid removing my strut-brace.

Warren has a point, if the car is totally stock (read: no alarm an aftermarket ECU/head unit) then it should probably hold the charge for several months infact. You might be able to use a multimeter to ascertain how much current draw is on the battery while the car is off. (apart from the boot light which will be on while you test the battery!)

your options:

1 - as you said it could be a flat battery. theyare usually rated at about 4 years lifetime.. so how old is yours?

My battery is almost 3 years old, and don't find any problems if I drive it everyday.

---

Andy, mine's just a little 330cca. My factory strut-brace meant that I couldn't run a larger battery.

By "larger" I mean;

More powerful batteries are usually bigger in physical size too. The R33 Skyline battery holder will allow two different sizes of batteries, but I had to use the smallest type to avoid removing my strut-brace.

My local auto-electrician recommend what they stock:- fully sealed battery with 430CCA. Does more CCA mean anything after the car is running??

get your alternator checked out mate!!

I will definitely get that checked too...

thanks for the advice guys~

Get your auto electrician to check the 'parasitic' load. Some component of the car might be draining too much power when its off. It should be be under 50mA. I know my car goes flat after 2 weeks cos my parasitic load is roughly 100mA which is definitely too much.

God knows what component it is though. I suspect its my shitty alarm.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Then, shorten them by 1cm, drop the car back down and have a visual look (or even better, use a spirit level across the wheel to see if you have less camber than before. You still want something like 1.5 for road use. Alternatively, if you have adjustable rear ride height (I assume you do if you have extreme camber wear), raise the suspension back to standard height until you can get it all aligned properly. Finally, keep in mind that wear on the inside of the tyre can be for incorrect toe, not just camber
    • I know I have to get a wheel alignment but until then I just need to bring the rear tyres in a bit they're wearing to the belt on the inside and brand new on the outside edge. I did shorten the arms a bit but got it wrong now after a few klms the Slip and VDC lights come on. I'd just like to get it to a point where I can drive for another week or two before getting an alignment. I've had to pay a lot of other stuff recently so doing it myself is my only option 
    • You just need a wheel alignment after, so just set them to the same as current and drive to the shop. As there are 2 upper links it may also be worth adding adjustable upper front links at the same time; these reduce bump steer when you move the camber (note that setting those correctly takes a lot longer as you have to recheck the camber at each length of the toe arm, through a range of movement, so you could just ignore that unless the handling becomes unpredictable)
    • I got adjustable after market rear camber arm to replace the stock one's because got sick of having to buy new rear tyres every few months. Can anyone please let me know what the best adjustment length would be. I don't have the old ones anymore to get measurements. I'm guessing the stock measurement minus a few mm would do it. Please any help on replacing them would be fantastic I've watched the YouTube clips but no-one talks about how long to set the camber arm to.
    • Heh. I copied the link to the video direct, instead of the thread I mentioned. But the video is the main value content anyway. Otherwise, yes, in Europe, surely you'd be expected to buy local. Being whichever flavour of Michelin, Continental or Pirelli suits your usage model.
×
×
  • Create New...