Jump to content
SAU Community

Recommended Posts

Hi,

I got defected for an after market BOOST controller, (i got a simple T piece unit)

so that make that is illegal to have on the car.

my question is: a Pillar illegal?

I am thinking of geting a pillar to hold my boost gauge.

Maybe i just gona mount it where the radio used to sit.

cheers,

darrien

Edited by ZXFIRE
Link to comment
https://www.sau.com.au/forums/topic/107212-legalillegal/
Share on other sites

I didnt get defected for a boost gauge,

he pulled me over and pop the bonet,

got defected for:

- POD, need to box it

- After market Boost controller

- not standard exahust

just asking about a pillar because i thinking of geting 1,

the boost controller sit in my engine similar to this, execept my hose and boost unit is all black

I did NOT know boost controller is defective,

thats y, Bummer, stupid of me. :P

post-24486-1140846006.jpg

Edited by ZXFIRE
Link to comment
https://www.sau.com.au/forums/topic/107212-legalillegal/#findComment-1979657
Share on other sites

dammit, i have hidden my boost controller in the hope that it won't be spotted in the event of a search. Its an avcr, put controller in the glove box and assumed cops wouldn't know what to look at under bonnet. Bummer, may have underestimated them

Anyway i'm pretty sure a-pillar mounts are illegal as Wink said cause they're above the dash. It would prolly depend on what policeman u got looking too i guess

Link to comment
https://www.sau.com.au/forums/topic/107212-legalillegal/#findComment-1979744
Share on other sites

the A pillar gauges have to be outside of the area of head impact zone...in short...not higher than your cluster....other than that it's illegal...

wow the xops must know a lot abt cars to notice yout tvalve...

Edited by SKY 34
Link to comment
https://www.sau.com.au/forums/topic/107212-legalillegal/#findComment-1979815
Share on other sites

NO fine was issued,

- exhaust not standard,

that wat he puts down, didnt said it was loud.

gona get it tested, if it below 90db, hehhee, that shall shut them off from now ON.

but i got a silencer, ready, Bought from DANR33, (its good to have a back up plan) :)

It was a Minor defect, i can get it clear by AIS, that give pink slip. so i reckon it shouldnt be too hard,

Link to comment
https://www.sau.com.au/forums/topic/107212-legalillegal/#findComment-1980361
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • How would you even adjust the clutch if the pedal already has the correct free play? The operating cylinder has no adjustment in mounting position or rod length. On pull style clutches there is also no ability to adjust the bearing carrier. Push type I can see how adjusting the carrier height makes it all work.   If this is the twin plate clutch did you verify that your friction disks were oriented correctly? It's not mentioned in the directions at all you just have to notice that one side the friction disks have a part number on the hub fingers and a subtle coning to those fingers. Another thing that I noticed was if you put the friction disks in backwards the pressure plate fingers will not be even and flat when the clutch is installed.
    • yeah, mechanically, it is probably do-able, off the top of my head, there would be the transfer case, which I believe will bolt up to the rear of the RWD transmission, the shorter rear tail shaft. A front drive shaft, front diff, engine upper sump, front drive shafts, front hubs and front AWD struts (they are shaped around the front drive shafts), LCAs (at the very least from the front suspension) oil cooler.  You might want the rear diff from an AWD too, so you can be certain the front and rear diff rations are identical.  Who knows what brackets and mounts you might need.  So a whole doner car might be the best option if you need to maintain RHD. Then actually making it work, that would be a whole different story.
    • Take the fall as a warning sign for future endeavours  Stay safe mate
    • hi mate, HKS cooler piping still available by any chance?
×
×
  • Create New...