Jump to content
SAU Community

Recommended Posts

rear will depend on also what brake set up you have.I have converted to a 350z rear brake conversion, with 2 pot calipers on the rear and have difficulty finding rims to suit.

The silvia tear drop rims dont fit but the 7 star ceffy,silvia,180 rims miss the calipers.

Ive found anything with a 30+ish and up offset I can use.

Link to comment
https://www.sau.com.au/forums/topic/107416-wheel-fitment/#findComment-1981878
Share on other sites

offset of 38 works fine until you get coilovers which make the offset sink in! ;)

lowering without additional adjustment will create neg offset on rear ....i think mine has just over neg 2 degrees ......i have 17inch ... 8 inch +30 work meister s1's on the front and 9 inch + 35 on the rear. stacks of room around the brakes for future upgrades. They only scrape on the plastic crap on the inside of the gaurd at the front. +30 is max really for stock gaurds on the front. mine stick out about 4 to 5 mm .....

Link to comment
https://www.sau.com.au/forums/topic/107416-wheel-fitment/#findComment-1982285
Share on other sites

My old Orange ceffy had 18 x 11" rims on the rear........i am very UNcertain of the offset but i think it may have been -20ish.

There was about 7" of dish.

Obviously anything like that won't fit a vehicle that does not have the crazy/stupid bodymods that were carried out on that car.

Link to comment
https://www.sau.com.au/forums/topic/107416-wheel-fitment/#findComment-1997096
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...