Jump to content
SAU Community

Recommended Posts

R33 Factory Wheels (16") ....You guys know what car's they'll fit and what they wont..good for a back up set, or go halvies with a mate and have some burnout wheels...They have tyres on them, but they are not roadworthy.....i ripped them up before i got my rims..hehehe..

Like the wheels below

$265 Or Nearest Offer

2.jpg

Link to comment
https://www.sau.com.au/forums/topic/1076-r33-factory-wheels/
Share on other sites

Put me down for two of them, if anyone else will go halvies and take the other two that is? Remember a 16" tyre will flex more than a 17" and offer better traction at the drag strip, with a good tyre of course.

Link to comment
https://www.sau.com.au/forums/topic/1076-r33-factory-wheels/#findComment-23695
Share on other sites

Hehehe for $265 each rim you could nearly get a set of 18's witho ut tyres! heheh..

Nah man, its for the set....If you want em, take em...let me know via here or phone 0421 34 1981...Centre Caps included (they are damn hard to get these days!)

Regards

Sam

Link to comment
https://www.sau.com.au/forums/topic/1076-r33-factory-wheels/#findComment-23799
Share on other sites

I'm assuming the reason you go halves is just to run them on the rears with large profile tyres for dragging ? I was after them for a set for when I get defected, but I'd be happy to go halves, I will have to wait until next Friday though to deposit the $$$ due to pay week, but once again I'm more than happy to go ahead, just have to wait a week ...

Link to comment
https://www.sau.com.au/forums/topic/1076-r33-factory-wheels/#findComment-23923
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yea - I mean I've seen my fuel pump which is decades old and uh, while I'm not saying this with real knowledge... but I sure get the ick at using anything in the fuel system that produced the state of that pump. Many years ago I went through multiple pumps (and strainers) before I dropped the tank to clean it out with extreme violence. I'm talking the car would do maybe 50km before coming to a halt, which resulted in me cleaning out the filter with some brake cleaner and going on my way. None of my stuff ever looked like what came out of your fuel tank. I don't think I'd be happy with it unless every single component was replaced (or at least checked/cleaned/confirmed to be clean here).
    • I'm not going to recommend an EBC pad. I don't like them. Just about anything else would suit me better. I've been using Intima pads for a while now.
    • Agreed, and in particular the earth strap that should go from the subframe to the chassis but it often broken or left off. There is a section in the R32 workshop manual you can follow for troubleshooting if you don't see anything suspicious, and depending where you are (there is no location on your user profile) you should be able to get your hands on a second hand replacement unit still if needed
    • Yeah they mention as a R34 for 2.5 Turbo...but then again thos "small" were also for R34 by that different site. But i look into it and that 310mm EBC is for R34 GTT. And by those you linked the specs are the same 🙂    EDIT: I found these on one site here: DBA 4000 series T3 DBA42304S They are 310mm...and it says are for R34GTT...are there good? EDIT2: ok they have pads too.  What "color" should i get for street use? I dont want/need some noisy ones...(and if they are not that dusty that is good too)
    • Yeah, shame. Maybe  driver's carpet is available 🙏. I am waiting for both amayama and nangun to confirm.
×
×
  • Create New...