Jump to content
SAU Community

Recommended Posts

thanks mate.. iam realli happy with it..

mods are as follows..

full built motor..

HKS 2540 turbos

currently running 307kw at all four on 17psi

i went for more of a response setup than

outright power my turbos are boosting at

2000rpm and hitting full boost by bout 4500,

i noe i lost in overall power but it's just a lot

more feasable for driving on the street and

that's how i'd prefer it to drive.

  • 4 weeks later...

car: r33 gtr v-spec

R/T: 0.517

60': 1.976

ET 13.336 @ 103.95MPH (167.29km/h)

mods

rebuilt motor

standard turbos (rebuilt)

standard suspension

very hard sh#t tyres 255/40/17 at 25psi on rear and 28psi fronts

7psi boost(gauge displayed)

de-cat and back exhaust

will post up slip tomorrow

  • 2 weeks later...
  • 2 weeks later...
  • 2 weeks later...

12.805 @ 117mph

R32 GTR with full nismo exhaust, upgraded cooler (brand unknown), HKS pods and hard piping kit, standard PCM, standard turbo's with boost controller removed previously, exhaust manifolds opened up at turbo mating flange, standard fuel system and no EBC.

That was a few months ago. The engine has blown since then. I'll get back to you in a few weeks after I put the new motor in with gt-ss turbos, tomei fuel pump, SARD 700cc injectors, power fc and 19 psi of boost. Hopefully good things will come of the 12 grand + Ive spent on parts

  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • There's restrictor pills in the stock boost control hoses. That's how they set the amount that was bled off and hence the "high" boost setting. The usual mod in the day was to remove it and send the "high" boost setting up to about 14 psi.
    • Thanks Duncan, that's the best info I've read. Furthermore after learning about the PCM programming side controlling the factory boost solenoid, the purpose of the solenoid is to "bleed" boost when pin 25 is earthed, thus allowing spring pressure in the wastegate actuator to overcome diaphragm boost pressure, thus closing or reducing the position of the wastegate flap creating more boost as the turbo is able to spin faster. It's pretty cool to see a designated Pill to do exactly this, would have liked to have seen it with a tiny filter over the end for those moments in vacuum.  The constant bleed pill has now been removed completely from the system and solenoid boost control has been restored once again.   Case closed 😂
    • The wideband reading is meaningless if it's not running. Why are you using shitty old sidefeeds on any engine, let alone a Neo? What manifold and fuel rail are you using to achieve that? Beyond that, can't help you with AEM stuff as I've never been their ECU/CAS combo.
    • Manual boost controllers (where a little of the boost was bled off) were quite common back in the day, because they were cheap and easy. Generally they had a manual adjustment screw rather than being fixed like yours. Down side is they always bleed boost, not just when you want them to so an electronic boost controller that uses a solenoid will have less lag.
    • Hello , im new here and i have A31 home build  RB25det neo stock eng / turbo  aem ems 2 blue connector  aem 3.5 map aem cas disk aem wideband connected to ecu  355 lph pump 550 nismo yellow injectors side feed aftermarket regulator  and won’t start with base aem tuner basic tune eventually flipped cas 180 degree so it triggers on correct stroke not in exhaust cycle  Now it won’t start Wideband reads 10 and 11 at lowest fuel setting  and will share calibrations soon for aem tuner i think something is wrong in aem tuner    please if you have any information, am very grateful         
×
×
  • Create New...