Jump to content
SAU Community

Recommended Posts

hey fellas my names luos, i was just wondering if any yall got the spare time can you please chop my car for me like slam some deep dish rims on it sort of like the ones on the gtr in the pic and paint it like a wine red sort of a colour,with like a vertex type kit so i get a fair idea of i can do to it

chur bro

much appreciated

post-27863-1143968709.jpg

post-27863-1143968802.jpg

post-27863-1143969096.jpg

post-27863-1143969393.jpg

post-27863-1143969519.jpg

Edited by driftmunkee
Link to comment
https://www.sau.com.au/forums/topic/112056-chop/
Share on other sites

OK, it all starts with a good picture of the car, the third one there is not too bad, but you need to have not shadows or massive light changes (both apparent in pic 4) for a good colour change.

Take picture in the middle of an overcast day. Or search for wine red R32 pictures on google or something :thumbsup:

cheers

Link to comment
https://www.sau.com.au/forums/topic/112056-chop/#findComment-2066055
Share on other sites

  • 3 weeks later...
  • 3 months later...

nah man no pics of it out or being pulled out of the hole.

i had it pulled out with a franna crane some guys from downer engineeing

helped me out. i was actually heading the oppisite way to what the car is

facing in the picture. heres a couple of pics from when it was at the panelbeaters

after the first coat of paint.

post-27863-1155312597.jpg

post-27863-1155312654.jpg

Link to comment
https://www.sau.com.au/forums/topic/112056-chop/#findComment-2403222
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
×
×
  • Create New...